Lava SSERIAL-PCIE User Manual

LAVA SSerial-PCIe

Quick Installation Guide

P.N.MOKO L147.x

LAVA

SEMICONDUCTOR

INSL10200

MCS9901CV-AA

4E42503-06 0743

COMPUTERS

MADE

IN

CANADA

SS-550_LP PCIe

Pb

Rev.A00

RoHS

1

Windows 2000/

XP/Vista Installation

1. With the power turned off,insert the SSerial-PCIe card into any free
PCIe slot in your PC. Make sure the card is well seated.Turn your PC
on and start Windows.

2. Windows will automatically detect the SSerial-PCIe as a new PCIe
Serial Controller and ask you to insert the Installation Disk.Windows
should find the appropriate files and install them automatically.
Windows XP/Vista may display a message to the effect that the
drivers are not digitally signed.This warning can be ignored.

3. After the necessary files have been copied,Windows will complete
the full installation of the SSerial-PCIe.

4. If files are not found automatically,select Run from the Start Menu,
navigate to the CD,and run AutorunPro.EXE). Choose your card and
driver from the menus that appear.

The SSerial-PCIe hardware appears in Device Manager in the Ports tree.
(see next page). Please note that any changes to the Resources (I/O
Address & IRQ) used by the port on the SSerial-PCIe must be made
through the Resources page of the Port page.