LAUNCH TECH golo3 User Manual

golo3 User Manual

LAUNCH golo3 User Manual

ii

All rights reserved! No part of this publication may be reproduced, stored in a retrieval system or
transmitted, in any form or by any means of electronic, mechanical, photocopying and recording or
otherwise, without the prior written permission of LAUNCH.

This manual is designed only for the use of this unit. LAUNCH is not responsible for any use of this manual
on the other units.

The manual and all the samples herein can be changed without prior notice. Neither LAUNCH nor its
affiliates shall be liable to the purchaser of this unit or third parties for damages, losses, costs or expenses
incurred by purchaser or third parties as a result of: accident, misuse, or abuse of this unit, or unauthorized
modifications, repairs, or alterations to this unit, or failure to strictly comply with LAUNCH operating and
maintenance instructions.

LAUNCH shall not be liable for any damages or problems arising from the use of any options or any
consumable products other than those designated as Original LAUNCH Products or LAUNCH Approved
Products by LAUNCH.

Notice: other product names used herein are for identification purposes only and may be trademarks of
their respective owners. LAUNCH disclaims any and all rights in those marks.

This device is only for professional technicians and maintenance personnel.

LAUNCH golo3 User Manual

iii

Precautions:

z The socket-outlet shall be installed near the equipment and shall be easily accessible.
z The golo3 is a precision electronic instrument. Observe caution when handing the module. Dropping

the module can cause damage.

z Make sure that the connection between the golo3 module and DLC socket is secure and reliable

when in use,

z GPRS transmission speed depends on mobile network, communication timeout failure would be

occurred when network is busy (such as major festivals), and it also prone to happen in remote areas,
Launch would not responsible for any consequences occurred by this failure.

z ODB program is pre-installed in the factory; please go into http://mycar.x431.com/

to download the

diagnostic software corresponding with your vehicle.

z Turn off the ignition switch when connecting or disconnecting the golo3 module to the vehicle’s OBD

II Diagnostic Linking Connector (DLC).