MOTORCYCLE ALARM SYSTEMS
GB 850H-850T USER GUIDE
OPERATING INSTRUCTION
BUTTON 1 BUTTON 2 |
Pict. 1 |
FLASHES WHILST
A REMOTE BUTTON
INDICATES THAT THE
BATTERY IS GETTING
LOW
ALARM ARMING: Push button no.1; arming is signalled by two flashes of the direction lights. After 30 seconds all sensor circuits are active, except the ignition circuit which is instant after arming.
ALARM DISARMING: Push button no.1; disarming is signalled by one flash of the direction lights and one acoustic signal.
PANIC FUNCTION: Pressing the button no .2 you will activate the siren for 10 seconds. If you wish to stop it during this time, push it again.
ALARM CONDITIONS SIGNALLING
If any alarm conditions occurred while you where away from the motorcycle: DURING DISARMING, look at the direction light:
SHORT FLASH OF DIRECTION LIGHT: an alarm conditions occurred. LONG FLASH OF DIRECTION LIGHT: no alarm conditions occurred.
SENSORS TEST
Arm the alarm by remote handset.
CONTACT SENSORS: wait 30" before activing the contact switch connected to the grey wire. ANTILIFT SENSOR: after 30" tilt the motocycle.
IGNITION SWITCH SENSOR: Turning ON the ignition switch will cause an alarm condition and the engine will not start.
Every test will cause an alarm condition: siren will sound for 30 seconds, and then reset for 10 seconds; after this time alarm system will be ready for any other alarm condition.
Loading...