Lanzar WDN2000.1D User Manual

WDN800.2D

9	4				7				8	1
POWER STATUS	CROSS OVER								HI-LEVEL
	FULL
GREEN=ON			HIGH					L	R	L
			PASS
RED=PROTECTION	LOW			0			180
					PHASE					LINE IN
	PASS
LEVEL		BASS BOOST				H P F		L P F		R
MIN	MAX	0DB	12DB		50HZ		150HZ	50HZ	150HZ

2

3

5

6

9		4		7			8
POWER STATUS		REMOTE
GREEN=ON				0 PHASE180		L	R
RED=PROTECTION							HI-LEVEL
LEVEL
MIN	MAX	20HZ	50HZ	0DB	12DB	50HZ	150HZ
		SUBSONIC		BASS BOOST		L P F
	2		5	3			6

WDN2000.1D

1

L

LINE IN

R

1.Line Input RCA J acks: These inputs are for signal cables

	from the source.
2	.Input Level Control:		Enables the matching of input levels
	to the output levels from the source.
3.V ariable Bass Boost: 0 ~ 12 dB
4	.Crossover M ode: Low pass, F ull range or H						igh pass
5	.H igh Pass F ilter:		V ariable from 5	0	H	z	to 15	0	H z
6	.Low Pass F ilter:	V	ariable from 5 0	H	z	to 15 0		H	z
7	.Phase Switch: 0	° or 180 °

8.H igh Level Input: If your head unit does not have RCA outputs, use the speaker outputs for the audio source.

9 .Power & Protection Indicators: The bi-color LED glows green when power is on and no problems are present.

If one of the protection circuits comes on, it will change to red.

1.Line Input RCA J acks: These inputs are for signal cables from the source.

2 .Input Level Control: Enables the matching of input levels to the output levels from the source.

3.V ariable Bass Boost: 0 ~ 12 dB

4.Remote Bass Control: Remote controls the subwoofer level.

5.Subsonic: This setting acts as a low frequency cut off for your

	subwoofer. The subwoofer will not play frequencies below the
	subsonic setting.
6	.Low Pass F ilter:	V ariable from 5 0 H z to 15 0 H z
7	.Phase Switch: 0	° or 180 °
8.H igh Level Input: If your head unit does not have RCA
	outputs, use the speaker outputs for the audio source.
9	.Power & Protection Indicators: The bi-color LED glows
	green when power is on and no problems are present. If
	one of the protection circuits comes on, it will change to red.

WRATH 1