Lanpro LP-1520AI Installation Manual

Wireless - Equipment

www.lanpro.com

123 Fast Installation Guide LanPro’s LP-1520ai Radio

in Mode AP

LP1520ai_M123_END01W

123 Fast Installation Guide

LanPro’s LP-1520ai Radio

in Mode AP

Wireless - Equipment - LP-1520ai WLAN AP - 123 Fast Intallation Guide

This Fast Installation Guide will let you perform a fast installation of this device.

Check the box contents and physical installation as per the following list:

1

LP-1520ai Radio.
LP-PoE150 Injector
Power cable.

Physical connections

2

Connect the Data + Power UTP Cable coming from the LP-PoE150 injector
to the Watertight connector on the bottom of the LP-1520ai Radio from
LanPro.

Connect a Cat5e cable as per the 568a or 568b standard from the port
marked as Data on the LP-PoE150 to the Switch. (In case you want to
confi gure the Radio in a direct manner, please use a crossed cable).

Logical Confi guration

3

Please go to your Network Card (NIC) properties as shown in fi gure 1 and confi gure the IP

3.1

protocol to obtain an IP address automatically as shown in fi gure 2.

Figure 1

Open your preferred Browser and input the following address: 192.168.1.254 as shown in

3.2

fi gure 3. The confi guration window will pop-up but won’t ask for a Username or Password.

Note: remember to select a Username and password for your equipment as the
confi guration might be accesed by any one.

Figure 2

Figure 3

2

www.lanpro.com