Lang Manufacturing USA-24-6 Service Manual

Panne Bella Thermostat Conversion

The Panne Bella Griddles (Model USA 24-6) with serial number prefi x “A” have an old style
thermostat. This thermostat has 6 lugs with 4 incoming wires and one jumper between 2 lugs.
The new style has two lugs and two incoming wires. The following instructions explain the
electrical wiring changes needed to replace the old style thermostat with the new style.

List of Materials

P/N Nomenclature Quantity

2T-30402-35 Thermostat & Screws 1
2C-31301-01 Wire Nut 1
2C-31006-01 Ring Terminals 2

6472814-08 5/32 Drill Bit 1

2M-60902-28 Instructions 1

WARNING

DISCONNECT ELECTRICITY BEFORE PERFORMING THIS
PROCEDURE. FAILURE TO COMPLY MA Y RESULT IN INJURY
OR DEATH.

1.

Disconnect power from the griddle.

2.

Remove wires #1 and #2 from the old thermostat and connect together with the ceramic wire nut.

3.

Remove wires #3 and #4 from the old thermostat and remove the spade connectors from the wire

ends.

4.

Remove the knob from the stem of the thermostat.

5.

Remove and discard the old thermostat.

6.

Using a template with the dimensions below and the drill bit provided, drill two holes for

mounting the new thermostat.

7.

Install the ring terminals provided on wires #3 and #4.

8.

Install the new thermostat with two screws through the drilled holes.

9.

Connect wires #3 and #4 to the new thermostat.

10.

Install the knob on the stem of the thermostat.

11.

Restore power to the unit.

07/8”

07/8”

3

4

3

2

3

°0 5/32

13/4”

Mounting Hole Template

Star Manufacturing International 10 Sunnen Drive St. Louis,MO.63143-3800
Part Number: 2M-60902-28 Ph:314-781-2777 Fax:[phone]

Rev.- WWW.STAR-MFG.COM January 15, 2006

1

2

Old Style ThermostatNew Style Thermostat

4