Page 1
Page 2
Page 3
Page 4
4
Page 5
The LV412A cabinet is the ideal speaker enclosure for use with
the LV range of Laney amplification.
the Laney range.
The is a 4 x 12” cabinet rated at 280 watts (8 ohms)
LV412A
and can be used in isolation or combined with other Laney
enclosures. Construction features a robust plywood cabinet,
with large side mounted bar handles for ease of portability,
textured black fret material & steel corner protection.
Every Laney product is extensively play tested by experienced
guitarists to ensure it has the tone and durability to perform at
the very highest level, before being shipped to our customers.
We hope you enjoy using your new extension cabinet as much
as we enjoyed designing and making it. It should give you years of trouble-free service, however please take
time to read this manual, as it will allow you to get the best from your LV412A Cabinet.
Best wishes from all at Laney.
- or indeed any amplifier in
Page 6
In order to take full advantage of your new product and enjoy long and trouble-free performance,
please read this owner's manual carefully, and keep it in a safe place for future reference.
1). Unpacking: On unpacking your product please check carefully for any signs of damage that may
have occurred whilst in transit from the Laney factory to your dealer. In the unlikely event that there
has been damage, please repack your unit in its original carton and consult your dealer. We strongly
advise you to keep your original transit carton, since in the unlikely event that your unit should
develop a fault, you will be able to return it to you dealer for rectification securely packed.
2). Amplifier Connection: In order to avoid damage , it is advisable to establish and follow a pattern
for turning on and off your system. With all system parts connected, turn on source equipment, tape
decks, cd players, mixers, effects processors etc, BEFORE turning on your guitar amplifier. Many products
have large transient surges at turn on and off which can cause damage to your speakers.
By turning on your guitar amplifier LAST and making sure its level control is set to a minimum, any
transients from other equipment should not reach your loud speakers. Wait till all system parts have
stabilised, usually a couple of seconds. Similarly when turning off your system always turn down the
level controls on your guitar amplifier and then turn off its power before turning off other equipment
3). Cables: Never use shielded or microphone cable for any speaker connections as this will not be
substantial enough to handle the amplifier load and could cause damage to your complete system.
4). Servicing: The user should not attempt to service these products. Refer all servicing to qualified
service personnel
6
Page 7
Laney
Dimensions W 715 x H 728 (over feet) x D 358
Cabinet
Design
Rugged plywood construction, black
metal corners, black textured fret
material, comfortable side bar handles
and rubber feet.
Weight 30Kg
Impedance 8 Ohms
Drivers 4x12" Custom Designed Drivers
LV412A
Power RMS 280 Watts
Inputs 2 x 6.3 Jack sockets
PO W E R TO T H E M U S I C
www.laney.co.uk
Model:
412A
Power Rating 280W
Serial Number:
Input
Link
Designed in the UK by Laney
8 Ohms
Made In China
7
Page 8
OPERATING INSTRUCTIONS Issue 1.1
Loading...