Landoll W-360 User Manual

W-360 Rear S-Tine Spacer Instruction Sheet

Front

1

2

3

4

3

4

1

2

The Rear S-Tine Spacer will prevent the rear S-Tines
from coming in contact with the roller wheels.

Installation:

Place the spacer against the rear frame weldment, lining
up the top two bolt holes. Insert two 1/2” x 6-1/2” bolts

Rear S-Tine Spacer

through the weldment then the spacer, slide the S-Tine
bracket over the bolts, secure with 1/2” lock nuts. See
Illustration below. Repeat for the eight other spacers.
Wing spacer installation similar.

Rear S-Tine Spacer

ITEM PART NUMBER DESCRIPTION QTY.

1 184610 SPACER S-TINE 9
2 1-654-010055-18 SCR, HX CP, 1/2-13UNCX6-1/2 GR5 18
3 9J091 BRACKET, S-TINE 9
4 1-512-010005-09 NUT, HEX, SLFLKG, 1/2-13 GRB 18

F-770

IMPORTANT

After installing the S-Tine Spacers, and when the S-Tine

W360 SpacerInstSht

S-Tine in Raised Position

Correct Pin Position

184610
Spacer

Center Link

3/4” Flat Washer

3/4” Flat Washer

Pin,3/4” x 2-3/4”

Cotter Pin,1/8” x 1-1/4”

Control Arm

Control Arm is connected to the Center Link ensure the
rear most hole in the Center Link is used. See the
Illustration below.

F-770