Landmann 28051 Installation Manual
Parts List (continued)
A1
B
W
D1
C1
U
X
I
J
T1
E1
F2
F1
H1
L1
4
Y
Hardware
TOOLS REQUIRED
Phillips
screwdriver
Adjustable
wrench
HARDWARE INCLUDED
NOTE: Hardware not shown to actual size.
AA
(30) M6 x 12mm Bolts (30) M6 Hexnuts (2) M6 Capnuts (2) M8 Locknuts(10) Washers
BB
CC
Assembly
1
Assembling the firebowl
handle
2
DD
EE
Assembling the front legs
Assemble the firebowl handle (T1) to the
front of the firebowl (E1) using two bolts (AA), two
hexnuts (BB) and two washers (DD).
Assemble the bolts and washers from inside
the firebowl. Tighten bolts securely.
DD
BB
T1
AA
E1
Assemble the two front legs (L1) to the firebowl (E1) using
four bolts (AA), four washers (DD) and four hexnuts (BB).
Finger tighten the bolts only at this time.
KEEP ROUND
EDGE TOWARDS
THE CENTER OF
FIREBOWL
L1
DD
BB
5
AA
E1
Assembly (continued)
4
Assembling the bottom shelf
3
Assemble the bottom shelf (Y) into the front legs (L1)
using two capnuts (CC). Finger tighten the capnuts
only at this time.
Y
L1
CC
Assembling the wheel legs
Insert the right and left wheel legs into the bottom shelf axle.
Assemble each leg to the firebowl using two bolts (AA), two
washers (DD) and two hexnuts (BB). Tighten the bolts and
capnuts from Steps 2 and 3.
F1
AA
E1
DD
BB
Y
KEEP ROUND
EDGE TOWARDS
THE CENTER OF
FIREBOWL
F2
5
Assembling the wheels
Assemble the two wheels (H1) to the bottom shelf axle
(Y) using two locknuts (EE). Tighten hexnuts securely.
Y
H1
EE
Assembling the firebowl
6
handle shield
Assemble the firebowl handle shield (U) to
the handle (T1) using two bolts (AA)
and two hexnuts (BB).
BB
U
T1
AA
6
Loading...