Pulse™375
Getting Started Guide
Guide de Démarrage
Guía de Inicio Rápido
Pulse375 manual AMR.qxd 7/23/03 12:53 PM Page 1
The Pulse™375, Model: S-0103A/B speaker system provides convenient controls and a space-saving
design. Simply connect and enjoy!
English
English
Connecting your speakers to your PC
You can connect your speakers to your computer soundcard, or to an external audio source, such as a CD
player, cassette tape deck, or radio.
For optimum sound quality, place the subwoofer on the floor beneath your desk being careful not to block the
bass port. Be sure to maintain 6 inches of spacing around the subwoofer to allow for adeuqate ventilation.
These speakers can also be connected to your video game console using a video game console
adapter available at many consumer electronics stores.
Move switch to “Stand By” on
control pod.
1. Black plug to SPK OUT.
2. Green plug to AUDIO OUT on
PC, or other audio source.
3. Plug power cord into outlet.
4. Move switch on control pod to
“I” (on) position.
5. Adjust Volume.
LINE IN
SPK OUT
1
2
3
5
4
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Unplug the speakers from the computer and from the
electrical outlet before cleaning them with a dry cloth.
• Install in accordance with the manufacturer’s instructions.
• Place the speakers in a stable location so they will not fall
causing damage to the speakers or bodily harm.
• Do not use the speakers near water, and do not immerse
them in any liquid or pour any liquid on them.
• Do not block the openings in the speaker cabinets, never
push objects into speaker vents or slots because of fire or
electric shock hazards, and provide sufficient space
around the speakers for proper ventilation.
• Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
• Do not defeat the safety purpose of the polarized plug. A
polarized plug has two blades with one wider than the
other. The wide blade is provided for your safety. If the
provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
• Operate the speakers only from the low level audio line
out jack of the computer or of an audio device.
• Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
• Only use attachments/accessories specified by the
manufacturer.
• For added protection during lightning storms, unplug the
speakers from the electrical outlet and turn off the
computer.
• Unplug this apparatus when unused for long periods of
time.
• Servicing is required when the apparatus has been
damaged in any way, such as when the power-supply
cord or plug has been damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
• Refer all servicing to qualified service personnel.
• The speakers should be disconnected from the mains by
placing the power/standby switch in the off position and
unplugging the power cord of the speakers from the AC
mains receptacle.
• The socket-outlet shall be installed near the equipment
and shall be readily accessible.
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.
IMPORTANT SAFETY INFORMATION
CAUTION
ELECTRIC SHOCK HAZARD
Pulse375 manual AMR.qxd 7/23/03 12:53 PM Page 2
Troubleshooting
See below for solutions to common problems. If you have more questions about your Labtec speakers, visit
www.labtec.com.
Speakers produce weak or no sound.
• Is the power light on? Make sure the speakers are plugged into an electrical outlet and the power button
is on.
• Is there output from the soundcard? Try connecting the speakers to an alternative audio source - for
example, a CD player, cassette tape deck, or radio. If there is sound from the speakers, the problem is
probably with your soundcard. If no other sound source is available, try removing the plug from the
soundcard and turning the speaker to maximum volume. You should hear a hum or buzz when you touch
the tip of the plug. If you do, the speaker is OK, and you should check your soundcard setup.
One speaker doesn’t produce sound.
• Is the soundcard connection secure? Make sure the cable from the soundcard to the main speaker is
properly secured.
• Is the balance control centered on your PC?
Specifications
• Total RMS Power: 10 Watts
Subwoofer: 6 watts RMS into 4 ohms at 100Hz at 10% THD (total harmonic distortion)
Satellites: 4 watts RMS (2 x 2 w) into 4 ohms at 1 kHz at 10% THD (total harmonic distortion)
• Total Peak Power: 20 Watts at <10% THD
• System THD: Better than 0.05% THD before clipping
• Signal to noise ratio: > 72 db
• Frequency response: 55 Hz – 20 kHz
• Drivers:
Satellites: 2.75” high excursion driver
Subwoofer: 4” Max-X
TM
coil driver
• Speaker dimensions:
Satellites: (H) 7” x (W) 4” x (D) 2.25”
Subwoofer: (H) 8” x (W) 5.75” x (D) 8.25”
English
English
Product Warranty
Limited Warranty. Labtec warrants that any hardware product accompanying this documentation shall be free from significant defects in
material and workmanship for a period of one (1) year from the date of purchase. Labtec's limited warranty is nontransferable and is limited to
the original purchaser. This warranty gives you specific legal rights, and you may also have other rights, which vary under local laws.
Remedies. Labtec’s entire liability and your exclusive remedy for any breach of warranty shall be, at Labtec’s option, to: (a) repair or replace
the hardware, provided that the hardware is returned to the point of purchase or such other place as Labtec may direct, with a copy of the
sales receipt, or (b) refund the price paid. Any replacement hardware will be warranted for the remainder of the original warranty period or
thirty (30) days, whichever is longer. These remedies are void if failure of the hardware has resulted from accident, abuse, or misapplication.
DISCLAIMER OF WARRANTY. THE WARRANTIES EXPRESSLY SET FORTH IN THIS AGREEMENT REPLACE ALL OTHER WARRANTIES. LABTEC AND
ITS SUPPLIERS EXPRESSLY DISCLAIM ALL OTHER WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OF THIRD-PARTY RIGHTS WITH RESPECT TO THE
HARDWARE. NO LABTEC DEALER, AGENT, OR EMPLOYEE IS AUTHORIZED TO MAKE ANY MODIFICATION, EXTENSION, OR ADDITION TO THIS
WARRANTY. Some jurisdictions do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
LIMITATION OF LIABILITY. IN NO EVENT WILL LABTEC OR ITS SUPPLIERS BE LIABLE FOR ANY COSTS OF PROCUREMENT OF SUBSTITUTE
PRODUCTS OR SERVICES, LOST PROFITS, LOSS OF INFORMATION OR DATA, OR ANY OTHER SPECIAL, INDIRECT, CONSEQUENTIAL, OR
INCIDENTAL DAMAGES ARISING IN ANY WAY OUT OF THE SALE OF, USE OF, OR INABILITY TO USE ANY LABTEC PRODUCT OR SERVICE, EVEN IF
LABTEC HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN NO CASE SHALL LABTEC'S AND ITS SUPPLIERS’ TOTAL LIABILITY
EXCEEDS THE ACTUAL MONEY PAID FOR THE LABTEC PRODUCT OR SERVICE GIVING RISE TO THE LIABILITY. Some jurisdictions do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. The above limitations
will not apply in case of personal injury where and to the extent that applicable law requires such liability.
© 2003 Labtec. All rights reserved. Labtec, the Labtec logo, and other Labtec marks are owned by Labtec and may be registered. All other
trademarks are the property of their respective owners.
Pulse375 manual AMR.qxd 7/23/03 12:53 PM Page 4
Loading...