Karcher PS 40 Owner's Manual
PS 40 Powerscrubber
English . . . . . 3
Français . . . . . 5
Español . . . . . 7
59640930 02/11
2
Please read and comply with
these original operating instructions prior to the initial operation and store
them for later use or subsequent owners.
Proper use
The PS 40 Powerscrubber can be used
with all KÄRCHER high-pressure cleaners
(starting with construction year 1992) up to
a pressure of 16 Mpa (160 bar ( 2300 psi).
The PS 40 is ideally suited for the highpressure cleaning and scrubbing of stairs
and smooth floor surfaces outside (e.g.
wooden or stone floors, clinker, tiles, concrete) as well as of floor surfaces with a water discharge inside (e.g. wash-room,
garage).
This attachment has been designed for use
in private households and is not intended
for commercial use.
Description of the Appliance
When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport damages please contact your dealer.
Illustrations on Page 2
Illustration
1 PS 40 Powerscrubber
2 Pull-off lip
3 Extension tube
4 Extension pipe with safety sleeve/
handle
Safety instructions
Please observe the safety instructions
of your high-pressure cleaner.
Only trigger the high-pressure jet at the
high-pressure gun if the PS 40 is located on the surface to be cleaned.
There must be no persons in the imme-
diate vicinity of the cleaning head.
Beware of the recoil force! Ensure a
stable position and firmly hold on to the
high pressure gun with the extension
pipe.
Switch off the high-pressure cleaner
when you finish cleaning. If you are using the PS 40, then disconnect the
same from the high-pressure gun.
Maximum water temperature 60°C
(please observe the instructions of your
high-pressure cleaner).
English 3
Loading...