KYOSHO KF01 Ball Diff. Set User Manual
Before commencing assembly, please read these instructions thoroughly!
Ball Diff. Set
for KF01
INSTRUCTION SHEET
No.KFW006
Thank you for purchasing this product. Before installation, please carefully read and follow the instructions on this sheet
in conjunction with the instruction manual of your kit.
Symbols used throughout the instruction manual, comprise:
Apply grease.
1/8
Diff Ball
4.8x10mm
Thrust Bearing
5mm
4x 4mm
Taper Washer
Set Screw
Must be purchased
separately!
6x10mm
8
5x10mm
1
1
Bearing
Bearing
Apply threadlocker
(screw cement).
2
1
Firmly tighten the set screws
1
onto the at spot.
Diff Washer
4x 4mm
Assemble in the
specified order.
Ball diff can be adjusted by tightening or loosening
the wheel nut.
6x10mm
Bearing
5x10mm
Bearing
Taper Washer
Note the direction
SPARE PARTS
Set Screw(M4x4/10pcs)
Shield Bearing(5x10x4)4Pcs
Shield Bearing(6x10x3)2Pcs
Ball Diff. Shaft
1/8
4.8x10mm
Diff Ball
Thrust Bearing
6x10mm
Bearing
To find the appropriate ball diff setting, make small adjustments
and check by running the car. Please also refer to the below chart.
Too loose Diff slips.(Power loss) Tighten
Ideal Diff dosen't slip.(Smooth)
Too tight Diff dosen't work. Loosen
Thrust Bearing(4.8x10x4)1Pcs
Diff. Ball(1/8 Inch/10Pcs/SPADA09)
Thrust Diff. Ring(2Pcs/TF-5)
htpp://www.kyosho.com
*SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
© 2010 KYOSHO /
KFW006
64271010-2
PRINTED IN JAPAN
Loading...