KYORITSU 8246 User Manual
INSTRUCTION
MANUAL
DIP SW (DIP switch) 1 to 3 for the MODEL8246 Printer are set to the
settings in the following tables as the factory setting (factory default setting).
Default setting is Japanese. (No.1 to 5 of DIP SW2)
When having changed the settings or the printer does not operate normally, check
that
the settings are set to the default. If the settings are different from them, set the
settings again to the default.
For detailed information about the handling such the function setting, refer to
the instruction manual of the DPU-414 printer made by Seiko Instruments Inc.
■Applicable instruments
DIGITAL Multimeter MODEL KEW1061,KEW1062
■Accessories of Printer
MODEL 8246
Function Setting for Printer
<2> DIP SW2
Switch No. Function ON OFF
International
Character Set
<3> DIP SW3
Switch No. Function ON OFF
Baud Rate (bps)
1 Printing Columns
2 User Font Back-up ON OFF
3 Character Select
4 Zero 0 0
5～8
Switch No.
Japanese ON ON ON ON
1 Data Length 8 bits 7 bits
2 Parity Setting No Yes
3 Parity Condition Odd Even
4 Busy Control H/W BUSY XON/XOFF
5～8 Baud Rate Select See below
9600 OFF ON ON ON
International Character Set
5 6 7 8
5 6 7 8
Normal print
(40 columns)
Normal
character
Switch No.
Reduced print
(80 columns)
See below
Special
character
8248 AC adapter for printer
8247
8243
Thermal paper for printer
Printer Communication set
■ Function Setting for Printer
<1> DIP SW1
Switch No. Function ON OFF
1 Input Parallel Serial
2 Printing Speed High-speed Low-speed
3 Auto Loading ON OFF
4 Auto LF ON OFF
5 Setting Command Enable disable
6～8 Printing Density See below
(%)
100 OFF ON ON
6 7 8
Switch No. Printing Density
8-08
92-2003
Loading...