Kyocera KD135SX-UPU, KD215GX-LPU, KD135GX-LPU MOUNTING GUIDE
KKM-SM-0512
MOUNTING GUIDE
FOR THE
KD135SX-UPU, KD135GX-LPU～KD215GX-LPU
SOLAR PHOTOVOLTAIC POWER MODULES
Please read this guide carefully before installing the modules.
2009.12.01
KD series modules may be attac hed to a supp ort structur e
by the following methods. Detailed mounting method is
described in ‘mounting table’.
For optimal performance in all applications, clearance
between the module frame and the mounting surface is
required to allow cooler ambient air to circulate around the
back of the module and to avoid the module and / or wiring
damage.
The minimum spacing of .6” (15 mm) is required between
PV module and the mounting surface around the perimeter
of PV module. There should also be a clearance of at
least .13” (3.2 mm) between the individual modules to allow
heat-related expansion.
BOLTING: Utilizing 5/16” or 8 mm stainless steel hardware
through the existing .35” (9 mm) diameter mounting holes in
the module frame and then through module mounting holes
on the support structure. T ighten the screws with adequate
torque (132 in-lb).
Refer to the Module Drawings for the position of the solar
module mounting holes.
CLAMPING: Fasten modules firmly with clamps using
torque values specified by structure manufacturers.
Top-down clamps must have a minimum 40mm clamping
width, and minimum 9mm overlap onto module frame.
Clamps also must not shade the sunlight incidence on glass
surface. Clamp material must be either stainless steel or
anodized aluminum.
KKM-SM-0512
<KD205GX-L PU, KD210GX-LPU,
Mounting table- 1
Bolting
100mm
100mm
278.5mm 943mm
278.5mm
Top Down
Clamp
:
Permissible
clamping range
Long Side Short Side
943mm278.5mm 943mm278.5mm
100mm 100mm
100mm 100mm
943mm
100mm 200mm
100mm 200mm
943mm278.5mm
943mm278.5mm
100mm
100mm
KD215GX -LP U >
943mm278.5mm 943mm278.5mm
100mm
100mm
943mm
100mm 100mm
100mm 100mm
100mm
100mm
100mm 200mm
100mm 200mm
278.5mm 943mm
278.5mm
150mm
150mm
943mm278.5mm
943mm278.5mm
150mm
150mm
150mm
150mm
150mm
150mm
Continuous
Clamp
:
cont inuous clamp
200mm 100mm
200mm 100mm
278.5mm
278.5mm
943mm
943mm
943mm
943mm
200mm 100mm
200mm 100mm
278.5mm
278.5mm
Loading...