Kyocera 1001 Series, 06 1001 103 Instruction Manual

No.

: 205-03-330

取扱説明書

INSTRUCTION MANUAL

1001

圧着工具 Crimping Tool

06 1001 103

Series

O EDN19089 2019/04/15 H. Yoneno M. Isoe Y. Shimizu

NO EDN/DCN DATE PREPARED by CHECKED by APPROVED by

106-03-003

© 2019 KYOCERA Corporation

C

(mm)]

E

l

(mm)

r

06 1001 103 For 8283-3513 Contacts AWG#22-26

■Part Names

INSTRUCTION MANUAL

HAND CRIMPING TOOL

■Basic specification
Part No. 06 1001 103

Weight Approx. 420g

Dimensions 220 (W) x 70 (H) x 25 (D) mm

■Crimping conditions

Please make sure that the tensile strength of a contact
crimped by using this tool satisfies the following value.

Crimp height for

Position

A 22

B

■Applicable contact and wires

For special wires, please consult us separately.

Contact

60 8283

3513

XX 808

AWG No. of

applicable wire

24
26 2.0

Strip length 3.0 – 3.8mm

Style No. AWG No.

UL1061

strand

reference (mm)

Core wire

Coated wire

0.69 - 0.74 1.45 - 1.55

0.63 - 0.71 1.35 - 1.50

Wire

ore wire
[No. of
wires /

dia.

22 7/0.25 Ø 1.26
24 7/0.20 Ø 1.10
26 7/0.16 Ø 0.98

Tensile
strength,
minimum
value (N)

4.0

3.0

xterna
diameter of
coated wire

<Instructions for use>

- When setting a contact into or removing it from the
tool, do not hook the contact on the cable stopper or
the anvil. Or the contact could be deformed.

- When binding wires, loosen the wires so that no
stress could be applied to the contact directly.

- Set a contact in the right orientation.

- The ratchet is equipped so that the handles would not
open until proper pressure is applied.

- In order to release the ratchet as an emergency
measure against erroneous crimping, move the
ratchet release lever in the direction as shown in the
figure below.

Ratchet-release l eve

<Routine check>

1) After use, lubricate the teeth part with machine oil or
etc.

2) Make sure that the handles open/close smoothly

without any clinging or biting at the anvil or the
ratchet part.

3) If the impressing pressure of the ratchet is
decreased during a long-term usage, adjust the
ratchet. The ratchet unlock position could be
changed by the ratchet adjustment screw and the
fixing nut loosened and turned by using a
“specialized tool”. After adjusted, be sure to tighten
the nut. Before use it in the process, make sure that
the crimping operation is performed properly in a trial.

1001 SERIES INSTRUCTION MANUAL No. 205-03-330
106-03-004

© 2019 KYOCERA Corporation

PAGE 4/5