Page 1
Welcome!
TracVision Antenna
Switchplate
Data/Power
RF1
RF2
(Optional)
TV 1
TV 2
Receiver 2 Receiver 1
MAINTENANCE
15 VDC
Power
Supply
Vehicle/Vessel
AC Power
Grounding
Block
Vehicle/Vessel
AC Ground
HD
DIRECTV
DIRECTV
ON
POWE
RTV INP
U
T
FOR
M
AT
PWR
G
U
I
D
E
E
X
I
T
L
IST
AC
T
IVE
B
A
C
K
MEN
U
I
N
FO
OFF
& TV
RC
3
2
AV
1 AV2
TV
CHAN
P
A
G
E
VOL
PREV
EN
TER
1
2
3
4
5
6
7
8
9
0
abc
def
ghi
jkl
m
no
pqrs
tuv
wxy
z
SELECT
R
NETWORK
MAINTENANCE
ON
OFF
Basic Operation Switching Satellites
Troubleshooting
Congratulations! You have purchased the most reliable
satellite TV antenna system available today. Refer to
this guide for basic operation and troubleshooting
information. For installation information, refer to the
Installation Guide.
Product Serial Number
TracVision Serial Number
R5, In-motion
R4, Stationary (use only when parked)
C3, In-motion
TracVision System Diagram
©2008, KVH Industries, Inc. KVH and TracVision are registered trademarks of KVH Industries, Inc.
The unique light-colored dome with dark contrasting base is a registered trademark of KVH Industries, Inc.
ExpressVu is a property of Bell ExpressVu, a wholly owned subsidiary of Bell Satellite Services.
DISH Network is an official trademark of Echostar Communications Corporation.
DIRECTV is a registered trademark of DIRECTV, Inc.
All other trademarks are property of their respective companies.
54-0561A
Turning On the System
Stop your vehicle/vessel in an area with a clear 1.
view of the southern sky, away from any trees
or tall buildings.
Turn on your receiver and TV.2.
Set the switchplate’s Power switch to the ON 3.
(l) position.
Wait 1 minute for system startup.4.
Turning Off the System
Set the switchplate’s Power switch to the OFF (o)
position.
Product Care
Periodically wash the exterior of the dome with •
fresh water and mild detergent. Avoid harsh
cleansers or volatile solvents (e.g., acetone).
Do not spray the dome with high-pressure •
water.
If you wish to paint the dome, use only •
non-metallic automotive paint without a primer
coat. Metallic paint will impair reception of
satellite signals.
Certified Receivers
The following receivers have been certified by KVH
for use with your TracVision system.
Service HD Non-HD
DIRECTV* H21-200, H20-600 D12, D11, D10
DISH Network 211, 211k 311
ExpressVu 6100 3100
*Tri-Sat AutoSwitch required for KU-band HDTV.
KA-band HDTV is not currently supported.
Single-Receiver Setup
Your TracVision system automatically switches
satellites as you change channels using your
receiver’s remote control.
Note: Receivers might take up to 30 seconds to
display video when changing channels, switching
satellites, or switching between HD and non-HD
channels.
Multiple-Receiver Setup
The TracVision system tracks one satellite at a time.
Therefore, switching satellites with the primary
receiver might cause televisions connected to other
receivers to display different programming, no
programming, or an error message. Simply select a
channel carried by the new satellite, or switch back
to the original satellite.
DIRECTV
The TracVision system switches
satellites automatically as you
change channels using the
primary receiver’s remote control (the receiver
connected to RF1).
If your TracVision system is equipped with the KVH
Tri-Sat AutoSwitch Kit, any receiver equipped with a
Tri-Sat AutoSwitch can control satellite selection.
DISH Network and ExpressVu
The TracVision system switches
satellites automatically as
you change channels using
the primary receiver’s remote
control (the receiver connected
to RF1).
Note: The receiver might
briefly display an error message while the antenna
changes satellites.
Can the antenna see the satellite?
The antenna requires an unobstructed view of
the southern sky to receive satellite TV signals.
Common causes of blockage include trees,
buildings, bridges, and mountains.
Excessive dirt or moisture on dome?
Dirt buildup or moisture on the dome can reduce
satellite reception. Clean the exterior of the dome
periodically.
Is it raining heavily?
Heavy rain or snow can weaken satellite TV signals.
Reception should improve once the inclement
weather subsides.
Is everything turned on & connected?
Make sure your TV and receiver are both turned on
and set up for the satellite input. Finally, check any
connecting cables to ensure none have come loose.
Have you reset the receiver?
Receivers can sometimes lock up, preventing the
programming from being displayed on the TV. Turn
off and unplug your receiver. Wait one minute, then
plug it back in and turn it on.
Technical Support
If you are experiencing
any operational problems,
call or visit your local
authorized TracVision
dealer or distributor. You
can find an authorized
technician near you by visiting our website at
www.kvh.com/wheretogetservice.
If you need help finding an authorized technician,
please contact KVH Technical Support:
E-mail: techs@kvh.com
Phone: +1 401 847-3327
Page 2
Service Setup Service Setup
= DISH 61
Satellite
Recommended
MAINTENANCE
A
A
MAINTENANCE
A
B
B
Service Setup
When Setup is Required
DIRECTV
Your TracVision system is configured for DIRECTV
service by default. No action is required to receive
DIRECTV service.
DISH 1000
Your TracVision system should have been
configured for DISH 1000 during installation. If you
add a new receiver or install a receiver configured
for home use, proceed to Step 1 below to set up
that receiver for mobile use.
In addition, since DISH 1000 satellite coverage
varies by region, you can enjoy your DISH 1000
subscription nationwide by adjusting the setup for
either the 129 or 61 satellite - whichever best suits
your location. Proceed to Step 1 to adjust your
setup.
Service Key “A”
When required, this key connects to the DB9
connector located on the front of the switchplate.
Service Key “B”
When required, this key connects to the RJ22
connector located on the rear of the switchplate.
Service Key Usage for DISH Network/ExpressVu
Satellite Service Key A Key B
DISH 1000/129 - -
Step 3 - Verify Results
Verify that the values displayed on your TV 1.
match those shown for your selected service
in the following tables. If your values do not
match, repeat Step 2.
DISH 1000/129 Results
Port 1 2 3
Satellite
Trans
Status
Switch
DISH 1000/61 Results
Port 1 2 3
Satellite
Trans
Status
Switch
119 110 129
OK OK OK
Reception Verified
SW64
119 110 61
OK OK OK
Reception Verified
SW64
KVH TracVision
For detailed satellite coverage information, contact
DISH Network at 1-800-333-DISH.
DISH 500 and ExpressVu
Your TracVision system should have been set up for
your selected satellite service during installation.
However, if you add a new receiver or install a
receiver configured for home use, proceed to
Step 1 below to set up that receiver for mobile use.
Step 1 - Connect the Service Key(s)
All ExpressVu and some DISH Network setups
require connecting one or more of the service keys
supplied with your system. This section (continued
on the next page) explains which keys, if any, your
setup requires.
Note: If your setup requires connecting a Service
Key(s), be sure to connect it before proceeding to
Step 2.
DISH 1000/61 Connect -
DISH 500 Connect Connect
ExpressVu - Connect
Note: DIRECTV service does not require any service
keys or Check Switch tests.
Step 2 - Run Two Check Switch Tests
Stop your vehicle/vessel in a blockage-free 1.
area.
Ensure the receiver you need to configure is 2.
connected to RF1. Then turn on the TV and the
receiver.
Turn on the TracVision system. Wait 1 minute 3.
for system startup.
Using the receiver remote, go to the “Point 4.
Dish/Signal Strength” screen (press MENU
6,1,1 on most models).
Choose 5. Check Switch, then press SELECT.
Choose 6. Test, then press SELECT. Wait at least
15 minutes for the procedure to complete.
Repeat Steps 4-6 above to run a second test.7.
DISH 500 Results
Input 1 1 2 2
Satellite
Polarity
Status
Switch
ExpressVu Results
Input 1 1 2 2
Satellite
Polarity
Status
Switch
Exit the menu and allow the receiver to 2.
download the program guide. Once the guide
has loaded, you can start enjoying satellite TV.
119 119 110 110
Odd Even Odd Even
Reception Verified
SW42
82 82 91 91
Odd Even Odd Even
Reception Verified
SW21
User’s Guide
KVH Industries, Inc.
50 Enterprise Center
Middletown, RI 02842-5279
Phone: 1-401-847-3327
E-mail: info@kvh.com
Tech Support E-mail: techs@kvh.com
Loading...