Kreg PRS7850 User Manual

R

Precision Router

About the Stop

This stop was specifi cally designed for use with the Kreg Precision
Router Table. It can also be used with our Precision Benchtop Router
Table with the addition of select accessories. Call 1.800.447.8638 for
more information.

Table Stop Instructions

Thank you for purchasing this Kreg Precision Routing Accessory. The Router
Table Stop provides an easy and effi cient method for making incredibly
precise cuts, one after another.

WARNING: This product contains one or more chemicals known to the State
of California to cause cancer and birth defects or other reproductive harm.

Wash hands after handling.

*Blade Guard in image removed for clarity.

#PRS7850

Assembly Instructions

Nylon Screw

Used to calibrate
lens zero position

Nyloc Nut

Won’t work loose
during use

Brass Washer

Black T-Knob

Tightens Router Table Stop
assembly in position

Plastic Stop
Bushing

Allows for
smooth operation

Stop Positioning

Before assembly , determine which side of the blade you will be placing the
stop. If you will be placing it on the left side, you will need to put the Stop
Arm on the right side of the Stop Base (as shown below). If you will be
placing it on the right side, you will need to reverse the stop arm positioning
so that you can see how the stop aligns with the measuring tape.

Stop Tension

Depending on whether you want the stop to swing freely or stay
wherever you place it, you’ll need to adjust the tension of the Stop Arm.
To do this, simply tighten or loosen the nyloc nut until your desired
tension is met.

Lens Cursor

Because the tape on your Kreg Precision Router Table is not offset, and
the zero is precisely centered with your router bit, it is not necessary in
most situations to utilize the Precision Lens Cursor included with this
stop. However, if you plan on using this stop on another fence with an
offset tape, the Precision Lens Cursor will allow you to compensate for
the offset and will also magnify the tape for improved clarity.

Brass Washer

Plastic Stop
Bushing

Allows for
smooth operation

Hex Head Bolt

Secures Router Table
Stop assembly

Precision Lens
Cursor

Allows precise adjustment
of Router Table Stop

Plastic Support
Button

Allows for

Plastic Stop
Bushing

Allows for
smooth operation

T-Bolt

Slides in T-Slot of
aluminum trak

smooth operation

Stop Base

Anchors assembly to
aluminum trak

Router Table Stop Arm

Position on side of stop
base nearest blade

5/2010 FT4267

Rev D

KREG TOOL COMPANY
201 Campus Drive
Huxley, IA 50124

Precision Router Table Stop Parts Identifi cation

Name Dimensions Qty Part# Name Dimensions Qty Part#

Router Table Stop Arm 1 FT4263
Precision Lens Cursor 1 FT4063
Nyloc Nut 5/16” - 24 1 FT4061
Brass Washer 5/16” 2 FT4137
Nylon Screw 10-32 x 1/4” 1 FT4064
Black T-Knob 1 DK1313

Hex Head Bolt 5/16” - 24 x 3 - 1/4” 1 FT4060
Stop Base 1 FT4262
T-Bolt 1/4” - 20 x 1-1/4” 1 FT4212
Plastic Stop Bushing 4 FT4257
Plastic Support Button 1 FT4258

R