Kreg CT6066 User Manual

Screw Gun Kit

R

Assembly Instructions

Hose fi ttings

Screw Gun

Coil Hose

Locate the 1/4” NPT pipe plug on the lower right

1.

hand side of the main rail. Remove the pipe plug
using a 1/4” allen wrench. Once the pipe plug is
removed, thread one of the supplied fi ttings into the

hole. (Note: Thread sealer is already applied to the
fi tting, no other sealant should be needed. Tighten
the fi tting using a 11/16” socket or wrench. Do not
over tighten!)

Item# CT6066

Tools Needed:

• 1/4” Allen Wrench

• 11/16” Socket or Wrench

Kit Contains:

• (1) Screw Gun

• (1) Coil Hose

• (2) Hose Fittings

• (1) 6”, #2 Square Driver

• (1) Screw Gun Operating Instructions
WARNING: This product contains one or more

chemicals known to the State of California to cause
cancer and birth defects or other reproductive harm.

Wash hands after handling.

Remove the screw gun from the box and locate the

2.

Fig. 1

3.

Once both fi ttings are tight, install the blue
fl excoil hose to both the main rail and the gun.

This is done by simply pushing the hose into the
fi tting until you feel it seat in the fi tting. Now install
the 6” driver into the gun and you are ready to start

using your screw gun.

black plastic (see Fig. 1)
cap on the bottom of the
handle of the screw gun.
Remove this cap and
install the second air fi tting
supplied with this kit into
the screw gun using a
11/16” socket or wrench.

Pipe plug where the hose and gun will attach.

If you have any questions regarding these
instructions, please call 1.800.447.8638.

Hose and gun attached to the main rail.

5/2010 CT6065

Rev B