Page 1
INSTALLATION MANUAL
Novus Single Lever Basin Faucet
KEF-15401
www.kraususa.com I toll free: 1.800.775.0703 I © 2013-2014 Kraus USA Inc.
Page 2
Thank you for purchasing Kraus
We would like to take this opportunity to thank you for your business with Kraus
USA. It is our sincere hope that you are completely satised with your experience.
We welcome any questions or comments you may have, and will be glad to assist
you in the future.
For more information about Kraus products, please visit our website at:
www.kraususa.com
Please register your new Kraus product at the following web address in order to
activate the warranty and receive the full benet of customer support:
www.kraususa.com/registration
Sincerely,
Kraus Customer Service Department
Page 3
Prior to Installation:
Make sure you have all necessary parts by checking the diagram and parts list. If any part
•
is missing or damaged, please contact Kraus Customer Service at 800-775-0703 for a
replacement
• Turn o the hot and cold water lines at the angle stops and turn on the old faucet to
release any built-up pressure
• Pre-drilled countertop hole size requirement: 1-3/8” (min)
• Max countertop thickness: 1-3/8”
Page 4
13
Replacement Parts
9
10
12
7
8A
8B
8C
8D
1. (A) Index Button
(B) Set Screw
5
4
3
2
2. Metal Handle
3. Cartridge Cover
4. Locking Nut
1B
5. Cartridge
6. Faucet Body
11
1A
7. Rubber Washer
8. Mounting Hardware
(A) Rubber Washer
(B) Metal Washer
(C) Mounting Nut
(D) Mounting Screws
9. Aerator
10. Aerator Key
11. Hex Wrench
12. Hot & Cold Waterlines
Tools you will need:
Wrench Phillips Screwdriver
Pipe Tape
Silicone Sealant
(optional)
Safety Goggles
Page 5
Faucet Installation Procedure
170mm
(6.70”)
max30
Ø35
149mm
(5.86”)
125mm
(4.92”)
83mm
(3.26”)
(1.18”)
(1.37”)
Installer Tip:
Shut o main water supply before installing new faucet
Page 6
Step 1: Remove mounting hardware
Step 1
Step 2
8D
Step 2
Step5
9
10
8A
8B
8C
Step 2: Install hot & cold waterlines
Remove the mounting
screws (8D), mounting nut
(8C), metal washer (8B), and
rubber washer (8A) from the
mounting pipe
Place faucet on a soft cloth,
spout facing up. Attach the
waterlines into the base of the
faucet (HAND-TIGHTEN ONLY)
(A) Hot side left
(B) Cold side right
NOTE: Make sure O-rings are
installed on both ends of the hot
& cold waterlines
Page 7
Step 3
8A
8B
8C
8D
Step4
9
10
Step 3: Install faucet
Install faucet through 1-3/8”
predrilled hole in countertop.
Attach rubber washer (8A), metal
washer (8B), mounting nut (8C),
and mounting screws (8D) on the
threaded mounting pipe. Tighten
mounting nut (8C) until snug.
Tighten screws (8D) on mounting
nut (8C) with Phillips head
screwdriver until snug
8A
8B
8C
8D
Page 8
Step4
Step5
9
10
Step5
Step 4: Connect waterlines to main valve
Connect ex water supply lines
to angle stops and tighten with
adjustable wrench. Turn on both
hot and cold main valve
Apply pipe tape (optional)
Step 5: Flush faucet
9
After installing faucet, remove
aerator (9) with included aerator
key (10). Turn water on for 30
seconds to remove any debris.
Reassemble aerator (9)
Page 9
Trouble - Shooting
Hot
Water
Cold
Water
Push
If you have followed the instructions carefully and your faucet still does not work
properly, take the following corrective steps:
PROBLEM CAUSE ACTION
Leakage under the
handle
Aerator drips or has
inconsistent water flow
pattern
Water will not shut off
completely
Locking nut (4) has
come loose
Aerator (9) is dirty or
not seated properly
Cartridge may need to
be adjusted or replaced
Remove handle index
button (1a). Loosen
set screw (1b) with hex
wrench (9). Remove
metal handle (2).
Unscrew cartridge
cover (3) (by hand only).
Tighten locking nut
(4) with an adjustable
wrench
Unscrew aerator (9)
with aerator key (10)
and clean out debris
Remove handle index
button (1a). Loosen
set screw (1b) with hex
wrench (9). Remove
metal handle (2).
Unscrew cartridge
cover (3) (by hand
only). Unscrew the
locking nut (4) with
an adjustable wrench.
Remove ceramic disc
cartridge (5). Check for
cracks
Care & Maintenance
*To keep the product clean & shining, follow the steps below:
1. Rinse with clean water & dry with a soft cloth
2. Do not clean with soaps, acid, polish, abrasives, or harsh cleaners
3. Do not use cloth with a coarse surface
4. Unscrew the aerator and clean when necessary
*This installation manual is subject to change without further notice.
Page 10
Codes/Standards Applicable:
NSF/ANSI 372
GREEN
Water Eciency
LEAD FREE
I
A
P
M
O
R
&
NSF/ANSI 61
T
TM
ASME A112.18.1M
1.5GPM 5.7L/min maximum
KRAUS LIMITED LIFETIME WARRANTY
This product has been manufactured and tested to the highest quality standards
by Kraus USA Inc. (“Kraus”). We offer our customers thoughtfully crafted fixtures
& accessories, engineered for enduring performance over years of use.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original purchaser only. This warranty is not
transferable, between homes or owners and is only applicable to residential use.
WHAT IS COVERED BY THE WARRANTY
Kraus warranties this product against defects due to material or craftsmanship
error during the warranty period: Kraus will provide replacement parts at
no charge, or at its option, replace any product or part of the product that is
deemed defective, under normal installation, use, service and maintenance. If
Kraus is unable to provide a replacement and repair is not practical or cannot
be made in timely fashion, Kraus may elect to refund the purchase price in
exchange for the return of the product.
CONDITIONS AND EXCLUSIONS
Like other home fixtures, Kraus products will require light maintenance to
ensure proper function. We provide you with complete knowledge to perform
this maintenance and can also recommend resources if you are unable to fulfill
this service.
A. Kraus will not be responsible for product failures due to lack of maintenance
or proper use. Please read your care and maintenance documentation to determine the limits of proper use.
B. The original sales receipt, order number, and/or proof of purchase must be
presented at the time of the warranty claim, without exception, for this warranty
to be applied to all Kraus products.
Page 11
C. Kraus recommends installing all Kraus products with a licensed, professional
plumber. Kraus will not be held responsible for any damage or product failure
due to improper installation, misuse, or failure to use a licensed professional.
Please read your care and maintenance documentation to determine the limits
of proper use.
D. Commercial use will automatically void this warranty.
E. This warranty is not applicable to Kraus products purchased from an unau-
thorized seller. For a complete list of authorized sellers please visit http://www.
kraususa.com/where-to-buy.html
NONAPPLICABILITY OF THIS WARRANTY
By the purchase and use of our products, you agree that Kraus is not liable
for incidental, consequential or special damages associated with the return,
replacement, installation or use of your product. This includes freight costs,
cartridge replacement, labor, travel time, lost profit, home damages and other
contingent liabilities and costs (including, without limitation, costs associated
with experts, investigations, analyses, attorneys and other professionals and
services). The Kraus warranty is a comprehensive and explicit limit of liability,
and all items outside of it are not addressable by or the responsibility of
Kraus. Certain states have variances regarding implied warranties and in those
situations we remain fully compliant.
KRAUS USA Inc. makes no implication that products comply with any or all local
building or plumbing codes. It is the consumer’s responsibility to determine
local code compliance. This warranty extends to the original purchaser and first
consumer.
HELP LINE
For additional assistance at any point in the installation process, please call us at
1.800.775.0703 or email us at info@kraususa.com
Our customer service hours are Monday – Friday, 9am – 8pm EST.
Be sure to visit our website at www.kraususa.com
Page 12
www.kraususa.com
Loading...