Kraus KEF-15300 User Manual

Download

Page 1

INSTALLATION MANUAL

Aplos Single Lever Vessel Faucet

KEF-15300

Page 2

Thank you for purchasing Kraus

We would like to take this opportunity to thank you for your business with Kraus USA. It is our sincere hope that you are completely satised with your experience. We welcome any questions or comments you may have, and will be glad to assist you in the future.

For more information about Kraus products, please visit our website at:

www.kraususa.com

Please register your new Kraus product at the following web address in order to activate the warranty and receive the full benet of customer support:

www.kraususa.com/registration

Sincerely,

Kraus Customer Service Department

Page 3

Prior to Installation:

Make sure you have all necessary parts by checking the diagram and parts list. If any part

•

is missing or damaged, please contact Kraus Customer Service at 800-775-0703 for a

replacement

• Turn o the hot and cold water lines at the angle stops and turn on the old faucet to

release any built-up pressure

• Pre-drilled countertop hole size requirement: 1-3/8” (min)

• Max countertop thickness: 1-3/8”

Page 4

1B 1A

2 3 4

Replacement Parts

1. (A) Index Button

(B) Set Screw

2. Metal Handle

3. Cartridge Cover

4. Locking Nut

5. Cartridge

6. Faucet Body

7. Rubber Washer

8. Mounting Hardware

(A) Rubber Washer

(B) Metal Washer

(D) Mounting Screws

9. Aerator

10. Aerator Key

11. Hex Wrench

12. Hot & Cold Waterlines

Tools you will need:

Wrench Phillips Screwdriver

Pipe Tape

Silicone Sealant

(optional)

Safety Goggles

Page 5

Faucet Installation Procedure

max30

(1.18”)

Ø35mm

(1.37”)

G1/2

297mm

(11.69”)

(9.76”)

248mm

161mm

(6.33”)

(2.28”)

58mm

Installer Tip:

Shut o main water supply before installing new faucet

Page 6

Step 1: Remove mounting hardware

8A 8B

8C 8D

Step 2: Install hot & cold waterlines

Remove the mounting

screws (8D), mounting nut

(8C), metal washer (8B), and

rubber washer (8A) from the

mounting pipe

Place faucet on a soft cloth,

spout facing up. Attach the

waterlines into the base of the

faucet (HAND-TIGHTEN ONLY)

(A) Hot side left

(B) Cold side right

NOTE: Make sure O-rings are

installed on both ends of the hot

& cold waterlines

Page 7

8A 8B

8C 8D

Step4

Step 3: Install faucet

8A 8B

Install faucet through 1-3/8”

predrilled hole in countertop.

Attach rubber washer (8A), metal

washer (8B), mounting nut (8C),

and mounting screws (8D) on the

threaded mounting pipe. Tighten

mounting nut (8C) until snug.

Tighten screws (8D) on mounting

nut (8C) with Phillips head

screwdriver until snug

8C 8D

Page 8

Step 4: Connect waterlines to main valve

Connect ex water supply lines

to angle stops and tighten with

adjustable wrench. Turn on both

hot and cold main valve

Apply pipe tape (optional)

Step 5: Flush faucet

After installing faucet, remove

aerator (9) with included aerator

key (10). Turn water on for 30

seconds to remove any debris.

Reassemble aerator (9)

Page 9

Trouble - Shooting

Hot Water

Cold Water

Push

If you have followed the instructions carefully and your faucet still does not work

properly, take the following corrective steps:

PROBLEM CAUSE ACTION

Leakage under the handle

Aerator drips or has inconsistent water flow pattern

Water will not shut off completely

Locking nut (4) has come loose

Aerator (9) is dirty or not seated properly

Cartridge may need to be adjusted or replaced

Remove handle index button (1a). Loosen set screw (1b) with hex wrench (9). Remove metal handle (2). Unscrew cartridge cover (3) (by hand only). Tighten locking nut (4) with an adjustable wrench

Unscrew aerator (9) with aerator key (10) and clean out debris

Remove handle index button (1a). Loosen set screw (1b) with hex wrench (9). Remove metal handle (2). Unscrew cartridge cover (3) (by hand only). Unscrew the locking nut (4) with an adjustable wrench. Remove ceramic disc cartridge (5). Check for cracks

Care & Maintenance

*To keep the product clean & shining, follow the steps below:

1. Rinse with clean water & dry with a soft cloth

2. Do not clean with soaps, acid, polish, abrasives, or harsh cleaners

3. Do not use cloth with a coarse surface

4. Unscrew the aerator and clean when necessary

*This installation manual is subject to change without further notice.

Page 10

Codes/Standards Applicable:

NSF/ANSI 372

GREEN

Water Eciency

LEAD FREE

NSF/ANSI 61

ASME A112.18.1M

1.5GPM 5.7L/min maximum

KRAUS LIMITED LIFETIME WARRANTY

This product has been manufactured and tested to the highest quality standards by Kraus USA Inc. (“Kraus”). We offer our customers thoughtfully crafted fixtures & accessories, engineered for enduring performance over years of use.

WHO IS COVERED BY THE WARRANTY

This warranty extends to the original purchaser only. This warranty is not transferable, between homes or owners and is only applicable to residential use.

WHAT IS COVERED BY THE WARRANTY

Kraus warranties this product against defects due to material or craftsmanship error during the warranty period: Kraus will provide replacement parts at no charge, or at its option, replace any product or part of the product that is deemed defective, under normal installation, use, service and maintenance. If Kraus is unable to provide a replacement and repair is not practical or cannot be made in timely fashion, Kraus may elect to refund the purchase price in exchange for the return of the product.

CONDITIONS AND EXCLUSIONS

Like other home fixtures, Kraus products will require light maintenance to ensure proper function. We provide you with complete knowledge to perform this maintenance and can also recommend resources if you are unable to fulfill this service.

A. Kraus will not be responsible for product failures due to lack of maintenance or proper use. Please read your care and maintenance documentation to determine the limits of proper use.

B. The original sales receipt, order number, and/or proof of purchase must be

presented at the time of the warranty claim, without exception, for this warranty to be applied to all Kraus products.

Page 11

C. Kraus recommends installing all Kraus products with a licensed, professional plumber. Kraus will not be held responsible for any damage or product failure due to improper installation, misuse, or failure to use a licensed professional. Please read your care and maintenance documentation to determine the limits of proper use.

D. Commercial use will automatically void this warranty.

E. This warranty is not applicable to Kraus products purchased from an unau-

thorized seller. For a complete list of authorized sellers please visit http://www. kraususa.com/where-to-buy.html

NONAPPLICABILITY OF THIS WARRANTY

By the purchase and use of our products, you agree that Kraus is not liable for incidental, consequential or special damages associated with the return, replacement, installation or use of your product. This includes freight costs, cartridge replacement, labor, travel time, lost profit, home damages and other contingent liabilities and costs (including, without limitation, costs associated with experts, investigations, analyses, attorneys and other professionals and services). The Kraus warranty is a comprehensive and explicit limit of liability, and all items outside of it are not addressable by or the responsibility of Kraus. Certain states have variances regarding implied warranties and in those situations we remain fully compliant.

KRAUS USA Inc. makes no implication that products comply with any or all local building or plumbing codes. It is the consumer’s responsibility to determine local code compliance. This warranty extends to the original purchaser and first consumer.

HELP LINE

For additional assistance at any point in the installation process, please call us at

1.800.775.0703 or email us at info@kraususa.com

Our customer service hours are Monday – Friday, 9am – 8pm EST. Be sure to visit our website at www.kraususa.com

Page 12

www.kraususa.com