KRAMER ELECTRONIC S LTD.
USER MANUAL
MODELS:
WAV-5
WAV-5C
WAV-3
WA-1H
WAV-1R
WAV-1RP
Wall Plate Series
P/N: 2900-300124 Rev 2
Wall Plate Series – Contents
i
Contents
1 Introduction 1
2 Getting Started 2
2.1 Achieving the Best Performance 2
3 Overview 3
3.1 WAV-5 and WAV-5C Wall Plate Inserts 3
3.2 WAV-3, WA-1H, WAV-1R, WAV-1RP Wall Plate Inserts 6
Figures
Figure 1: WAV-5 4
Figure 2: WAV-5C 5
Figure 3: WAV-3 6
Figure 4: WA-1H (Front) 6
Figure 5: WA-1H (Rear) 7
Figure 6: WAV-1R (Front) 7
Figure 7: WAV-1R (Side) 7
Figure 8: WAV-1R (Rear) 7
Figure 9: WAV-1RP 8
Wall Plate Series – Introduction
1
1 Introduction
Welcome to Kramer Electronics! Since 1981, Kramer Electronics has been
providing a world of unique, creative, and affordable solutions to the vast range of
problems that confront the video, audio, presentation, and broadcasting
professional on a daily basis. In recent years, we have redesigned and upgraded
most of our line, making the best even better!
Our 1,000-plus different models now appear in 13 groups that are clearly defined by
function: GROUP 1: Distribution Amplifiers; GROUP 2: Switchers and Routers;
GROUP 3: Control Systems; GROUP 4: Format/Standards Converters; GROUP 5:
Range Extenders and Repeaters; GROUP 6: Specialty AV Products; GROUP 7:
Scan Converters and Scalers; GROUP 8: Cables and Connectors; GROUP 9:
Room Connectivity; GROUP 10: Accessories and Rack Adapters and GROUP 11:
Sierra Video Products; GROUP 12: Digital Signage; and GROUP 13: Audio.
Congratulations on purchasing your Kramer Wall Plate / Wall Plate Insert (each
supplied with the required screws), which is ideal for these applications:
Board rooms, conference rooms and training rooms
Presentation systems
Long distance signal distribution and home theater systems
2
Wall Plate Series - Getting Started
Go to http://www.kramerelectronics.com/support/product_downloads.asp to
check for up-to-date user manuals, application programs, and to check if
firmware upgrades are available (where appropriate).
i
2 Getting Started
We recommend that you:
Unpack the equipment carefully and save the original box and packaging
materials for possible future shipment
Review the contents of this user manual
2.1 Achieving the Best Performance
To achieve the best performance:
Use only good quality connection cables to avoid interference, deterioration
in signal quality due to poor matching, and elevated noise levels (often
associated with low quality cables)
Avoid interference from neighboring electrical appliances that may adversely
influence signal quality
Position your Kramer Wall Insert away from moisture, excessive sunlight and
dust
Wall Plate Series – Overview
3
3 Overview
This user manual describes the following wall plate inserts:
WAV-5 and WAV-5C (see Section 3.1)
WAV-3, WA-1H, WAV-1R, and WAV-1RP (see Section 3.2)
3.1 WAV-5 and WAV-5C Wall Plate Inserts
The WAV-5 (see Section 3.1.1) and WAV-5C (see Section 3.1.2), are available in
three versions: one for Belgium and Germany, one for England and Europe (except
Belgium and Germany), and one for the United States.
3.1.1 WAV-5
The WAV-5 is a 1 gang wall plate insert (see Figure 1) with pass through
connectors for:
Computer graphics video on a 15-pin HD connector and unbalanced stereo
audio on a 3.5mm jack connector flush against the front panel, and a short
flexible12cm(4.7”)cablewitha3.5minijackconnectorattherear
Video (composite or SDI) on a yellow RCA connector and unbalanced stereo
3.1.2 WAV-5C
The WAV-5C is a 1 gang wall plate insert (see Figure 2) with pass through
connectors and 5 cables with BNC connectors (colored red (R), green (G), blue (B),
black (Vertical sync) and yellow (Horizontal sync)) on the rear included for:
Computer graphics video on a 15-pin HD connector and unbalanced stereo
Video (composite or SDI) on a yellow RCA connector and unbalanced stereo
audio on RCA connectors (white for L and red for R)
audio on a 3.5mm jack connector flush against the front panel, and a short
flexible12cm(4.7”)cablewitha3.5minijackconnectorattherear
audio on RCA connectors (white for L and red for R)
4
Wall Plate Series - Overview
Figure 1: WAV-5
Wall Plate Series – Overview
5
Figure 2: WAV-5C
6
Wall Plate Series - Overview
3.2 WAV-3, WA-1H, WAV-1R, WAV-1RP Wall Plate Inserts
This section describes the following wall plate inserts:
WAV-3 (see Section 3.2.1)
WA-1H (see Section 3.2.2)
WAV-1R (see Section 3.2.3)
WAV-1RP (see Section 3.2.4)
3.2.1 WAV-3
The WAV-3 is a dual-insert wall plate insert (see Figure 3) with pass through
connectors for video (composite or SDI) on a yellow RCA connector and
unbalanced stereo audio on RCA connectors (white for L and red for R):
Figure 3: WAV-3
3.2.2 WA-1H
The WA-1H is a single-insert wall plate insert (see Figure 4) for unbalanced stereo
audio on a 3.5mm mini jack connector with a terminal block connector on the rear
(see Figure 5):
Figure 4: WA-1H (Front)
Wall Plate Series – Overview
7
Figure 6: WAV-1R (Front)
Figure 7: WAV-1R (Side)
Figure 8: WAV-1R (Rear)
Figure 5: WA-1H (Rear)
3.2.3 WAV-1R
The WAV-1R is a single insert wall plate insert (see Figure 6) for video (composite or
SDI) on a yellow RCA connector and unbalanced stereo audio on a 3.5mm mini jack
connector, with a terminal block connector on the rear (see Figure 7 and Figure 8):
8
Wall Plate Series - Overview
3.2.4 WAV-1RP
The WAV-1RP is a wall plate insert with pass through connectors for video
(composite or SDI) on a yellow RCA connector and unbalanced stereo audio on a
3.5mm mini plug connector (see Figure 9).
Figure 9: WAV-1RP
For the latest information on our products and a list of Kramer distributors,
visit our Web site where updates to this user manual may be found.
We welcome your questions, comments, and feedback.
Web site: www.kramerelectronics.com
E-mail: info@kramerel.com
P/N:
2900-300124
Rev:
2
!
SAFETY WARNIN G
Disconnect the unit from the power
supply before opening and servicing
Loading...