VS-3232DVI I/O Card Installation Sheet
The VS-3232DVI I/O Card mounts in one of the 16 expansion slots on the rear of the
VS-3232DVI chassis. Slots are numbered from left to right and must be occupied in sequential
order from left to right without leaving empty slots.
WARNING:
An input card must only be mounted in a slot designated for input cards (slots 1 to
4 and 9 to 12) and an output card must only be mounted in a slot designated for output cards
(slots 5 to 8 and 13 to 16).
To install an I/O card:
POWER
1. Power off the VS-3232DVI and all devices
connected to it.
2. Using a Phillips screwdriver, remove the
screws from the top and bottom of the
blanking plate.
3. Remove the blanking plate from the slot
and store it for possible future use.
4. Remove the new card from its shipping
box and anti-ESD bag.
CTRL
IN
1~4
IN
5~8
IN I N
9~12
13~16
OUT
1~4
OUT
5~8
OUT
9~12
OUT
13~16
IN
17~20
IN
21~24
IN
25~28
IN
29~32
OUT
POWER
CTRL
IN
1~4
IN
5~8
IN
9~12
IN
13~16
OUT
1~4
OUT
5~8
OUT
9~12
OUT
13~16
IN
OUT
25~28
OUT
25~28
17~20
17~20
OUT
21~24
OUT
29~32
IN
21~24
IN
25~28
IN
29~32
OUT
17~20
OUT
21~24
RESOLUTI ON
PATTERN
OUT
29~32
TEST
25~28
25~28
OUT
OUT
5. Holding the card by the connector plate, align the card
with the plastic guide rails.
6. Slide the card into the chassis until the front of the
card makes contact with the connector inside the chassis.
7. Press firmly on the upper and lower clips in order to
seat the card into the connector and align the clips with
the chassis.
8. Using a Phillips screwdriver, tighten the retaining
screws at the top and bottom of the card to secure it to
the chassis.
9. Power on the VS-3232DVI and follow the procedure in
the VS-3232DVI User Manual (see Section 9) to configure
the new card.
10. Power on the peripheral devices.
Kramer Electronics Ltd.
VS-3232DVII/OCardInstallationSheet
(P/N:2900-0006419REV1)
Loading...