VS-3232D DVI/HDCP I/O Card Installation Sheet
2900- 300019
2
The VS-3232D I/O Card mounts in one of the 16 slots on the rear of the VS-3232D
chassis. Slots are numbered from left to right.
WARNING An input card must only be mounted in a slot designated for input cards (slots
:
1 to 4 and 9 to 12) and an output card must only be mounted in a slot designated for
output cards (slots 5 to 8 and 13 to 16).
To install an I/O card:
1. Power off the VS-3232D and all devices
connected to it.
2. Using a Phillips screwdriver, loosen the
screws at the top and bottom of the
blanking plate.
3. Remove the blanking plate from the slot
and store it for possible future use.
4. Remove the new card from its shipping
PO
WE
R
CTR
L
DV
I
DVI
D
V
I
D
VI
DVI
D
VI
D
VI
DVI
D
VI
DVI
DVI
P
O
W
E
R
C
T
R
L
I
N
1~4
I
N
5~8
I
N
9~12
I
N
13~16
O
U
T
1~4
O
U
T
5~8
O
U
T
9~12
O
U
D
VI
13~16
DVI
D
V
I
D
VI
D
V
I
T
I
N
17~20
I
N
21~24
IN
25~28
I
N
29~32
O
U
17~20
T
O
21~24
PATTERN RESOLUTIO N
U
T
O
U
25~28
T
O
U
29~32
T
T
E
S
T
box and anti-ESD bag.
O
U
28
T
25~
5. Holding the card by the upper and lower handle, align the
card with the plastic guide rails.
6. Slide the card into the chassis until the front of the card
makes contact with the connector inside the chassis.
7. Press the card firmly into the slot until the connector plate is
flush with the rear panel of the chassis and the connector is
fully seated.
8. Using a Phillips screwdriver, tighten the retaining screws at
the top and bottom of the card to secure it to the chassis.
9. Power on the VS-3232D and follow the procedure in the
O
UT
28
~
25
VS-3232D User Manual (see Section 9) to configure the new
card.
10. Power on the peripheral devices.
VS-3232D DVI/HDCP I/O Card Installation Sheet
(P/N: 2900-300019 REV 2)
Kramer Electronics Ltd.
P/N:
Rev:
Loading...