1. Remove the two front panel screws on the
SID-X1N with the Allen L-shaped key (supplied).
2. Remove all the hexagonal spacers using a 5mm
socket spanner wrench (not supplied).
3. Remove the original front panel and replace with
the new SID-X1NBP black front panel.
4. Replace the hexagonal spacers and tighten with
the socket spanner wrench.
5. Replace the two front panel screws and tighten
with the Allen L shaped key.
P/N:
2900-300426
Rev:
1
SID-X1NBP (for SID-X1N) SID-X2NBP (for
SID-X2N) SID-X3NBP (for SID-X3N)
Black Front Panel R eplacement kit
Congratulations on purchasing your Kramer SID-X1NBP/SID-X2NBP/SID-X3NBP Black
Front Panel Replacement kit which is used to replace the gray colored front panel with a
black one so it can blend into the T10-22M inner frame of the TBUS-10xl or the T6F-03M
inner frame of the TBUS-6xl.
The kit includes a black SID-X1NBP/SID-X2NBP/SID-X3NBP front panel and an Allen L
shaped key. Note that these instructions refer to the SID-X1N but also apply, similarly, to the
SID-X2N and SID-X3N black panels.
To replace the front panel of the SID-X1N:
For the latest information on our products and a list of Kramer distributors, visit our Web
site where updates to this sheet may be found.
We welcome your questions, comments, and feedback.
Web site: www.kramerelectronics.com
E-mail: info@kramerel.com
KRAME R E L E C T RONICS LT D .
P/N: 2 900 -300426 REV 1
Loading...