PS-1DN Power Supply Installation
2
2900- 300231
The PS-1DN is a redundant, hot-swappable power supply for the VS-3232DN and
VS-6464DN Matrix Switchers. The switchers are able to continue to operate with a
minimum of one (VS-3232DN) or two (VS-6464DN) power supplies installed.
The VS-3232DN is shown as an example, the VS-6464DN follows the same principle.
To install a new power supply:
Note: The VS-6464DN must have a minimum of two working power supplies to operate
correctly.
WARNING: All normal static discharge precaution measures must be observed to prevent
damage to the equipment.
1. Remove the new power supply from its shipping box and anti-static bag. Place the
packaging including the anti-static bag to one side.
2. Remove the blank panel that covers the location of the new power supply by removing
the four thumbscrews.
3. Align the new power supply with the rails inside the space for the power supply and
slide it into the chassis. Ensure that you slide the power supply straight within the rails
until it makes contact with the rear
connector.
4. Press the power supply firmly into place
until the front panel of the power supply is
flush with the front panel of the chassis in
order to seat the rear connector.
5. Tighten the four thumbscrews.
Kramer Electronics Ltd.
P/N:
Rev:
PS-1DN Power Supply Installation
(P/N: 2900-300231 REV 2)
Loading...