Kramer PS-16DN Installation Guide

PS-16DN Power Supply Installation

2900- 300663

The PS-16DN is a redundant hot-swappable power supply for the VS-1616DN and

VS-1616DN-MD Matrix Switchers. The switchers are able to operate with one power

supply installed.

The VS-1616DN is shown as an example, the VS-1616DN-MD follows the same principle.

To install a new power supply:

WARNING: All normal static discharge precaution measures must be observed to prevent

damage to the equipment.

1. Remove the new power supply from its shipping box and anti-static bag. Reserve the original packaging including the anti-static bag for future use.

2. Remove the blank panel or the malfunctioning power supply by releasing the four thumbscrews.

3. Insert the new power supply and

press firmly into place until the front panel of the

power supply is flush with the front panel of the chassis.

4. Tighten the four thumbscrews.

Note: Each installed power supply requires a separate AC power connection and has

a dedicated power switch. Verify that the redundant power supply is connected to

AC power and is switched on.

Kramer Electronics Ltd.

P/N:

Rev:

PS-16DN Power Supply Installation

(P/N: 2900-300663 REV 1)