The Kramer MTH-3 VESA Adapter Bracket
i
Installation
Congratulations on purchasing your Kramer MTH-3 VESA Adapter Bracket for mounting
Kramer TOOLS™, Pico TOOLS® and MegaTOOLS® on the rear panel of large displays.
The MTH-3 VESA Adapter Bracket kit includes:
• MTH-3 VESA Adapter Bracket • Two spacers
To mount a tool on the MTH-3 VESA Adapter Bracket, do the following:
1. Remove the two M3x6 from the sides of the tool to be mounted.
2. Remove the two M3x8 screws (supplied with the MTH-3) from the Tool Brackets to use
in the following steps.
3. Place the tool (for example, a Pico TOOLS®) on the Tool Arm and attach the Tool
Mounting Bracket to the side of the TOOL with the M3x8 screw (Figure 2 A).
4. Attach the Adjustable Bracket to the other side of the TOOL with the second M3x8
screw (Figure 2 B).
5. Use the third M3x8 screw to fix the adjustable bracket to the appropriate slot
(for Pico TOOLS®, TOOLS™ or MegaTOOLS®, respectively) (Figure 2 B).
Figure 2: Installing a Pico TOOL
6. Slightly loosen the wing nuts to set the position of the MTH-3 to the desired angle and
then retighten the wing nuts.
Set the angle by inserting the pin on the Tool Arm into one of the holes in the Angle Adjustment Arm
7. Place the TOOL with the brackets over the rear side of the display, and position the
display mounting wing over two of VESA standard holes on the rear side of the display.
8. Place the two spacers between the Display Adapter Bracket and the display.
9. Place a spring washer (if supplied by the display manufacturer) over each of the two
screws (supplied by the display manufacturer).
10. Tighten the two screws to attach the MTH-3 to the rear side of the display.
Figure 1: MTH-3 VESA Adapter Bracket
The location of the screw-holes, as well as the number of screws used for each display may vary,
depending on the manufacturer
Note that both wing nuts can be loosened so that the position and angle of the
arms can be readjusted, and then retightened at the new position.
i
!
SAFETY WARNING
Disconnect the unit from the power
supply before opening and servicing
KRAMER ELECTRONICS LTD.
Installation
Instructions
MODEL:
MTH-3
VESA Adapter Bracket
For the latest information on our products and a list of Kramer
distributors, visit our Web site where updates to this user
manual/Installation instructions may be found.
We welcome your questions, comments, and feedback.
Web site:
E-mail:
www.kramerelectronics.com
info@kramerel.com
Figure 3: The MTH-3 Attached to the Rear Side of the Display
Note that the MTH-3 is attached to the rear side of the display using the screws
that were supplied with the display (either screwed into its rear side or in a
separate bag).
P/N: 2900-300110 Rev 1
Loading...