Koss TAP User Manual

Please do not plug in or power on any of your STRIVA devices until prompted to do so.

To activate and customize your STRIVA TAPs, go to:

They are charged and ready for activation.

Create an Account

Allow Java if prompted

User Name

Password

I forgot my password

www.mykoss.com

Dear UserName, Thank you for creating an account at myKoss.com. Please follow the link below to activate your new account.

http://10.102.5.24:8080/activate.a spx?action=activate&user=237&a ct=B738BA497307611EDD2A4B4 3374C3E686F0A1F84

If you don’t have Java,

install it ﬁrst

Click on “Let’s get started”

Create a MyKOSS account Check your email and click

on the MyKOSS link

+ ADD

Widgets

There are no channels in this account.

Welcome

To add a new channel, click the +ADD button above.

Create Channel

1. Select MUSIC

2. In the Channels Title Bar

2. In the Channels Title Bar click + ADD

click + ADD

Add Hotspot

Add STRIVA Device

+ ADD

Create a channel Customize channel

Widgets

Welcome

There are no Wi-Fi networks in this account. To add a new network, click the +ADD button above.

Create Channel

Add Hotspot

1. Select SETUP

2. Select WiFi

3. In the WiFi Hotspots title bar

3. In the WiFi Hotspots title bar click + ADD

click + ADD

Add STRIVA Device

+ ADD

Add Hotspot

Wi-Fi Network Name

Nickname

Security Protocol

WEP/WPA key

Security Protocol Open

Show Password

WEP/WPA key

Show Password

Cancel Save

This is the name of the hotspot. You can name the hotspot anything you want that will help you identify it easily

Open

Save

Cancel

Add a Wi-Fi hotspot Enter wireless information

Widgets

There are no STRIVA devices in this account.

Welcome

To add a new device, click the +ADD button above.

Create Channel

Add Hotspot

Add STRIVA Device

1. Select SETUP

2. Select Add/Remove

3. In the Add/Remove title bar click + ADD

Add STRIVA Device

Sync mode active for 3:00

Release when blue

+ ADD

I Don’t Have A STRIVA CAP

Plug in STRIVA CAP Click “Next” and wait for STRIVA

CAP to enter sync mode

Congratulations!

Your STRIVA TAPs are now fully operational

JOIN THE REVOLUTION

Power on STRIVA TAPs

Press and hold until BLUE light

illuminates to power on into

Wi-Fi streaming mode

Press and hold until

TEAL

light illuminates to power

on into STRIVA CAP mode

To stream media from STRIVA CAP:

For troubleshooting tips and FAQs, go to:

www.mykoss.com

VOLUME UNLOCK/LOCKMODE SWITCH STREAM SWITCH CHANNEL THUMBS UP/DN

TRIPLE TAP

for thumbs down

TRIPLE TAP

for thumbs up

SLIDE

for volume

HOLD

until beep to

unlock controls

TAP

for previous stream

TAP

for next stream

DOUBLE TAP

for previous channel

DOUBLE TAP

for next channel

VOLUME CONTENT

Press and hold until light illuminates to power

TEAL

on into STRIVA CAP mode

Micro USB Y-Cable

to Audio

CORDED LISTENING

STRIVA CAP to media source using

Micro USB Y-Cable

to USB

CHARGING

STRIVA TAPs

CONNECT

USB to audio cable

Mini USB

to Audio

STREAMING MUSIC FROM STRIVA CAP

SLIDE

for volume

IN THE BOX

Micro USB

to USB

STRIVA TAP SETUP STRIVA CAP SETUP

Mini USB

to USB

AND CHARGING

CONTROL

content from device

EAR CUSHIONS POWER

FOR BEST FIT FOR CHARGING

ADAPTER

WARNING

Please read these safety warnings carefully to ensure your personal safety and prevent property damage.

Do not leave your STRIVA devices in close proximity to open ames or extreme sources of heat. Do not expose your STRIVA devices to liquid or extreme humidity. Do not drop, disassemble, microwave, incinerate or paint your STRIVA devices. Do not expose your STRIVA devices to extreme high or low temperatures. Clean your STRIVA devices with a clean, dry cloth. Do not leave your STRIVA devices in direct sunlight for an extended period of time. Do not dispose of your STRIVA devices in a re. The battery could explode causing injury or death. Do not attempt to clean your STRIVA devices while they are being charged. Only charge your STRIVA devices with the components supplied with the STRIVA devices. Do not attempt to disable the STRIVA devices, chargers or cables or force open the built-in battery. Do not charge your STRIVA devices in damp areas or in extreme high or low temperatures. Do not leave or store the STRIVA devices or any of their accessories near or over your automobile’s airbags, because serious injury may result when an airbag deploys.

For more technical and safety information, go to

This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modications not expressly approved by the Koss Corporation may void the user's authority to operate the equipment.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.

This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment is in direct contact with the body of the user under normal operating conditions. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

www.koss.com

KOSS CORPORATION 4129 N PORT WASHINGTON AVE MILWAUKEE, WISCONSIN 1-800-USA-KOSS (1-800-872-5677) / WWW.KOSS.COM KOSS – EUROPE: CH – 6855 STABIO – SWITZERLAND

Product features and specications are subject to change without notice. Product may vary from images shown. Listen at moderate volumes to avoid hearing damage. KOSS, THE SOUND OF KOSS, KOSS and Design, and HEARING IS BELIEVING are Registered in U.S. Patent and Trademark Oce and are trademarks of the KOSS Corporation in other countries. STRIVA is a trademark of Koss Corporation. For patent information, see www.koss.com/patent

Made in the USA of U.S. and imported components.

FCC ID:L76-TAP IC:10021A-TAP

M/N:

FCC ID:L76-CAP IC:10021A-CAP

M/N:

Koss TAP User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual