Kompernass KH4218, KH4220, KH4221, KH4222, KH4223 User Manual

6

3D-ILLUMINATED
CHRISTMAS DECORATION

KH4218

KH4221

3D-ILLUMINATED CHRISTMAS DECORATION

Operating instructions

KH4219

KH4222

KH4220

KH4223

KOMPERNASS GMBH · BURGSTRASSE 21 · D - 44867 BOCHUM

www.kompernass.com

ID-Nr.: KH4218-4223-06/09-V1

3D-ILLUMINATED
CHRISTMAS
DECORATION

Read these operating instructions carefully
before using the appliance for the first time
and preserve this booklet for later reference.
Pass this booklet on to whoever might
acquire the appliance at a future date.

Intended Use

This 3D Illuminated Figure is intended exclu­sively for decorative purposes in domestic
indoor and outdoor areas and is not intended
for utilisation in commercial or industrial
applications. No warranty claims will be
approved for damage resulting from
improper use!

Items supplied

3D Illuminated Figure
4 Ground spikes
Operating instructions

Technical data

Operating voltage: 220 - 240 V ~ 50 Hz
Light source: 6,5 V ~ 70 mA
(= 0,455 W)
Power consumption: KH4218 = 100.8 W
KH4219 = 84 W
KH4220 = 134.4 W
KH4221 = 67.2 W
KH4222 = 100.8 W
KH4223 = 117.6 W
Protection class: IP44
(spray-water protected)
Safety class: II

Safety instructions

Risk of electric shock!

Do not permit children to handle electrical •
appliances without supervision - they
cannot correctly assess the potential
risks of injury.
Before taking the figure into use, ALWAYS •
check it for visible damage. Only connect
the rope light to electrical mains power
when it is in a faultless condition. Should
the rope light show any signs of damage,
contact the Service Centre listed below.
Do not use sharp or pointed objects,
such as wire or pegs, for securing the
figure.
The rope light may not be connected
electrically with another rope light.
Do not flex the rope light, this could •
damage it.
Avoid causing any damage to the insu-•
lation! IMMEDIATELY take the rope light
out of use should the insulation become
damaged.

Risk of potentially fatal

electrical shock!

The power cable cannot be repaired. •
In the event of damage to the power
cable, the appliance must be made
unusable and correctly disposed of.
ALWAYS first remove the plug from the •
wall socket before starting to clean the
rope light figure.
NEVER submerse the illuminated figure •
in water. Wipe it only with a slightly
damp cloth.
Position the illuminated figure in loca-•
tions at least 2 meters away from water
reservoirs or containers. Avoid locations
that could become flooded after heavy
rainfall.

- 1 -

When using the illuminated figure out-•
doors, use only a power socket that is
protected by a fault current circuit break­er (FI or RCD) with a maximum residual
current of 30mA.
The illuminated figure is protected against •
spray water (IP44). This type of protection
can only be maintained if the wall socket
being used is equipped with this type of
protection.
Do not pull on the power cable of the illu-•
minated figure and ensure that the power
cable is laid so that no one can walk on
or stumble over it. Ensure that the figure
has a safe and stable positioning.
To avoid damage to the illuminated figure,
please store it in its original packaging
after use.
Always take hold of the power cable •
by the plug. Do not pull on the cable
itself, and NEVER take hold of the power
cable, the plug or the rope light itself
with wet hands, as this could cause a
short circuit or an electric shock. Do not
place furniture or similar items on the
power cable and ensure that it cannot
become trapped. NEVER tie knots in
the power cable and do not bind it with
other cables. Place the power cable in
a position where it cannot be trod on.
A damaged power cable can cause a
fire or electrical shock. Check the power
cable from time to time.

Risk of fire!

Do not use the appliance adjacent to •
hot surfaces.
Do not place any open sources of fire, •
such as candles, close to the illuminated
figure.
When a storm and/or thunderstorm with •
the risk of lightening threatens, please
disconnect the illuminated figure from
mains power.
NEVER allow the figure to light up in its •
packaging, there is a risk of it overheating!
You may only place the illuminated figure •
on normal fire-retardant surfaces.
Notice regarding power disconnection: •
To completely disconnect the device from
mains power, the plug MUST be removed
from the power socket. For this reason
the device should be placed in a position
where unobstructed access to the power
socket is assured at all times, so that in an
emergency you will be able to immediately
remove the plug. To eliminate the risk of
fire, you should disconnect the plug from
the power socket if you do not intend to
use the device for an extended period,
for example, during a holiday.

Risk of accidents!

Do not hang or affix any objects to the •
illuminated figure.
Ensure that the power cable to the •
illuminated figure does not pass through
areas where lawnmowers, trimmers,
shears or similar cutting instruments
might be used.

- 2 -

Setting up the illuminated Figure

Cleaning and Care

Take the Illuminated Figure from its >
packaging.

Remove all transportation fasteners and >
tapes/foils.

Place the Illuminated Figure on a >
suitable surface.

Carefully pull the two wire elements apart, >
on the Christmas tree figure (KH4222)
and the Snowman figure (KH4220),
so that the figures can stand alone.

If necessary, secure the illuminated figures >
to the ground with the supplied ground
spikes.

Connect the Illuminated Figure with >
a correctly installed 230 V domestic
power wall socket.

When you wish to turn off the illumina- >
tion function of the Illuminated Figure,
remove the plug from the wall socket.

During the periods in which the Illumi- >
nated Figure will not be in use, please
store it in its packaging.

Risk of potentially fatal

electrical shock:

First remove the plug from the power •
socket.
NEVER submerse the Illuminated Figure •
in water or other fluids!
Do not allow any liquids to permeate •
into the Illuminated Figure.

Before you start cleaning it, allow the Illu- >
minated Figure to cool down if need be.

Cleaning the Rope Light:

Clean the rope light with a lightly mois- >
tened cloth. NEVER use petrol, solvents
or detergents that can damage plastics!

Maintenance

The illuminated figure contains no parts •
that can be serviced by the consumer.

Disposal

Do not dispose of the device in
your normal domestic waste.
This device is subject to the European
Guidelines 2002/96/EC.

Dispose of the appliance through an •
approved disposal centre or at your
community waste facility.
Observe the currently applicable regu-•
lations. In case of doubt contact your
disposal facility.

Dispose of all packaging materials
in an environmentally friendly
manner.

- 3 -

CE Conformity

This device has been both examined and
approved in regard to conformity with
the fundamental requirements and other
relevant regulations of the EMC Directive
2004/108/EC and the low voltage
directive (LVD) 2006/95/EC.

Importer

KOMPERNASS GMBH
BURGSTRASSE 21
44867 BOCHUM, GERMANY

www.kompernass.com

Warranty & Service

The warranty for this appliance is for 3 years
from the date of purchase. This appliance
has been manufactured with care and meti­culously examined before delivery. Please re­tain your receipt as proof of purchase date.
Should a claim need to be made under the
warranty, please make contact by telephone
with our service department. Only in this way
can a post-free despatch for your goods be
assured.
The warranty covers ONLY claims for
material and maufacturing defects, not for
wearing or consumable or for damage
to fragile components. This product is for
private use only and is not intended for
commercial applications.
The warranty will become void in the event
of abusive and improper handling, use of
force and internal tampering not carried or
approved by our authorized service branch.
Your statutory rights are not restricted in
any way by this warranty.

DES Ltd

Tel.: [phone]

Fax: [phone]
e-mail: [e-mail]

Kompernass Service Ireland

Tel: [phone] (0,082 EUR/Min.)

Standard call rates apply. Mobile operators may vary.

e-mail: [e-mail]

- 4 -