Kompernass KH 4042 User Manual [el]

3B

JUMP LEADS

KH 4042

HÄAD

Operating instructions

ΚΑΛΩ∆ΙΟ ΕΚΚΙΝΗΣΗΣ

Οδηγίες χρήσης

KOMPERNASS GMBH · BURGSTRASSE 21 ·

D-44867 BOCHUM

www.kompernass.com

ID-Nr.: KH4042-07/08-V2

KH 4042

A

B

JUMP LEADS 16 MM 2

Read the operating instructions carefully before using the appliance
for the first time and preserve this booklet for later reference. Pass
the manual on to whomsoever might acquire the appliance at a
later date.

ΚΑΛΩ∆ΙΟ ΕΚΚΙΝΗΣΗΣ

16 MM 7

Φυλάξτε αυτή την οδηγία για ερωτήσεις που θα προκύψουν
αργότερα – και σε περίπτωση παράδοσης της συσκευής δώστε την
επίσης σε αυτούς που θα την αποκτήσουν!

- 1 -

JUMPER LEADS 16 MM
KH4042

Intended use

These battery jumper leads are intended exclusively for private use and for
utilisation in the brief bridging of a flat standard commercial starter battery
(lead battery for vehicles) with a power source of 12 V - 24 V. These battery
jumper leads may ONLY be used for supplying power to petrol motors
with a cylinder capacity of up to 2500 cm
diesel motors!).

Technical data

3

(they are NOT suitable for

Cable length: 3 m Cross-section: 16 mm
max. Cylinder capacity: 2500 cm3Petrol motor / NO diesel motors!

- 2 -

2

Safety information

• Before starting the bridging procedure, be sure to check the details given
in the operating handbooks for BOTH vehicles.

• Check to ensure that the two batteries have the same rated voltage (e. g.
12 Volt). The capacity (details in Ah) of the supplier battery should not
be significantly smaller than that of the receiver battery.

• Ensure that the permitted cylinder capacity limits of the battery jumper
leads are not being exceeded by the vehicles.

• There may NOT be any bodywork contact existent or possible between
the two vehicles.

• The ignition on both vehicles MUST be switched off before the battery
jumper leads are connected. Additionally, the hand brake must be activated
and, for manual vehicles the gear lever must be in neutral, for automatic
vehicles the selector lever must be in the position P.

• During the starting procedure both batteries must remain properly
connected within their vehicles. An interruption could lead to the destruction
of the dynamo/alternator!

Warning: Risk of electric shock!

• Always follow the sequence described for attaching and detaching the
cables, and for starting the engines!

Risk of explosion!

Under no circumstances should you connect the black cable directly to the
minus pole of the receiver battery, should you do so there is the risk that
detonating gas may explode when making/breaking the connection!

Keep open lights, heat or electrical sparks well away from the batteries.
There is a risk of deflagration!

- 3 -