10 GB/ IE
A Maintenance and Cleaning
A Maintenance
a Changing the Dust Bag (TYPE KH 99)
You can see that the dust bag i is completely
full when the filling level indicator q in the
viewing window is 100 % RED.
• Turn the vacuum cleaner off and disconnect
the power cord A from the mains.
• Press the release button
{
on the cover of
the dust collection container and open the
cover.
• Remove the full dust bag
i
from the dust
bag holder u by pressing the clamping
lever.
• Insert a new dust bag of TYPE KH 99 or
type Swirl
®
Y 101 ® into the dust bag
holder.
Note:
If no dust bag is inserted it is not possible to
close the cover!
a Changing the Filter
• Switch the vacuum cleaner off and disconnect
the power cord A from the mains.
• Press the release button
{
on the cover of
the dust collection container and open the
cover.
• Remove the full dust bag
i
from the dust
bag container u by pressing the clamping
lever.
Motor Protection Filter
The motor protection filter o protects the motor
compartment against dirt (see illustration B).
• Remove the motor protection filter
o
from
the holder.
• Replace the filter insert by another one.
• Then reinsert the motor protection filter o
in the holder.
Exhaust Air Filter
The exhaust air filter p collects fine dusts
which would otherwise be given off to the
surrounding air. The exhaust air filter should be
changed after a visual check (see illustration F).
If a replacement is needed, this can be
purchased from our service addresses.
• Remove the exhaust air filter
p
from the holder.
• Replace the entire exhaust air filter
by a new one.
• Insert the new exhaust air filter
p
into the
holder and allow it to click into place.
a Thread Catcher
Through the use of the thread catchers on the
underside of the floor nozzle I, threads and
fluff are vacuumed up particularly thoroughly.
Worn thread catchers can be levered out with an
appropriate tool. If a replacement is needed, this
can be bought from our service addresses.
A Cleaning
• Switch the vacuum cleaner off and disconnect the power cord A from the mains.
• Please use a dry cloth for cleaning.
• The device should never be cleaned with
moisture!
• Use a brush or tweezers to remove threads
from the floor nozzle I, or vacuum these
off from time to time with the crevice
nozzle r.
Maintenance and Cleaning