- 4 -
KH 660
Technical Data
Mains voltage: 230 V~ / 50 Hz
Power rating: 60 W
Volume of collecting vessel: 600 ml
KB-time: 10 Minutes
Proper Use
The Ice Crusher is exclusively meant for
crushing ice into small bits for home use
only. The Ice Crusher is not intended for
commercial use.
Description of the appliance /
accessories
Lid
Filling shaft flap
Casing
Ice shovel
Collecting vessel (max. 600 ml)
ON/OFF switch
Lever for the filling shaft flap
• Instruction manual
• Warranty card
Operation
➩ Before you use the Ice Crusher for the
first time, remove all packing material
and make sure that all accessories are
present.
Fire hazard: Never exceed the
maximum operating duration of
10 minutes. Allow the appliance
to cool down for 2 minutes before
switching it on again.
Injury hazard: Never insert objects
or your fingers into the filling shaft.
This is can cause injuries, as the cutters may be rotating inside.
➩ Connect the power cord plug to the
mains.
➩ Press the ON/OFF switch and
allow the appliance to run for a few
seconds, before you fill in ice cubes.
➩ Remove the lid .
➩ Place an ice cube over the filling shaft
flap .
➩ Pull the lever until the ice cube falls
into the grinder.
➩ Place the lid back into position and
hold it firmly on the top.
➩ If the ice cube is crushed, repeat the
operation with the next ice cube.
Note: Too much ice can cause blockage
or seizure of the grinder assembly.
In such a case...
➩ switch the Ice Crusher off and unplug
the cord.
➩ Remove excessive ice or wait till the
ice is melted and the grinder assembly
is defrosted.
When the collecting vessel is full...
➩ Draw out the collecting vessel and
remove the crushed ice using the ice
shovel .