Kolcraft SN001, SN004, SH005 Owner's Manual
F03S-T 10/07
1-2-3 Learn with Me™Potty Chair Instruction Sheet
Hoja de instrucciones para silla de entrenamiento
para ir al baño solito, 1-2-3 Learn with Me
™
1-2-3 Learn with Me™Directives pour le siège
d’aisance pour enfants
2
Read all instructions BEFORE assembly and USE of this product.
Failure to
follow warnings and instructions could result in injury or death to
your child. Make sure the potty seat is fully assembled and secure
before use.
Keep instructions for future use.
IMPORTANT SAFETY INFORMATION:
If product is broken or damaged, contact Kolcraft Enterprises, Inc.
Consumer Services Department at 1-800-453-7673.
How to Keep Your Child Safe While Using this Product
• CAUTION: Adult assembly required.
• Do not exceed 40 lbs. / 18 kg.
• This product is for use by children ages 18 months and up.
• Never leave child unattended while using this potty seat.
• Assemble anti-skid grippers to bottom of base before using this
potty seat.
• When using the potty seat on adult toilets, adult supervision is
required.
• Do not lift or carry product by Elmo’s face or hand.
• Do not lift product while child is on it.
• Do not use potty seat on cushioned toilet
seats; potty seat may not secure properly or
potty seat could damage toilet seat.
• Do not use seat as a step stool.
• Always use potty seat and step stool on a
level surface.
• Do not immerse the base in water.
• Do not remove face unit.
FCC Statement (United States Only)
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
WARNING
Continued on next page
3
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Consult the dealer or experienced radio / TV technician for help.
Note: Changes or modifications not expressively approved by
the manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
Parts List
Tool Needed: Phillips Screwdriver
Deflector Shield
Lid Seat Waste TubBase Unit
Reward Book
Reward StickersAnti-Skid
Grippers (3)
• Replace batteries included with this product before using.
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium).
• Remove batteries during long periods of non-use. Battery leakage and corrosion
can damage this product.
• Never short circuit the battery terminals.
• Only batteries of the same or equivalent type as recommended should be used.
• Rechargeable batteries are to be removed from the product before they are charged.
Battery Tips
4
How to Install Batteries
1
2
CAUTION: Adult Assembly Required.
Remove the waste tub from the potty
base unit.
Turn base unit upside down and lay on a
flat surface.
Remove the lid from the underside
of the base unit and locate battery
compartment in front of product.
Unscrew the battery door with a Phillips
screwdriver.
DISPOSE OF THE 3 DEMONSTRATION
BATTERIES INCLUDED IN PRODUCT
BEFORE USE.
Insert 3 new “AA” batteries as shown.
Replace battery door and tighten the
screw.
NOTE: The battery door is designed so
that it only fits in the correct orientation.
CAUTION: Do not mix old and new
batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.
Remove batteries before storing the
product for a prolonged period of time.
3
4
5
4
1
6
Battery Door Screw
6
5
How To Turn Unit ON/OFF and Select Language
The potty seat randomly plays 10
phrases in English and Spanish. It can
be set to High Volume, Low Volume or
turned Off. The switches are located
above the battery compartment.
The potty is shipped in “High” volume
(+) and in “Demonstration” mode (C).
Turn the off / volume switch to “+” for
high volume, “-” for low volume, and
“O” for Off.
Turn the language switch to “A” for
Spanish mode or “B” for English mode.
The “C” is for demonstration mode.
Press Elmo’s hand to test the sound.
Elmo will randomly say 10 fun phrases in
the language selected.
PHRASES
• Elmo is so proud of you
• It's potty time with Elmo
• You're learning to use the potty
•
It's fun to use the potty
• You're growing up just like Elmo
• Great job
• Congratulations
• Way to go
• Yeah, You did it
• Hurray, Hee, Hee, Hee, Hee
1
2
3
2 & 3
4
Off / Volume Switch
Language Switch
4
Elmo’s Hand
How To Assemble Potty Seat
CAUTION: Adult Assembly Required.
The face is the front of the unit.
Attach the anti-skid grippers to the
bottom of the unit as shown.
When using as a potty seat, store the lid
under the base by pushing the lid into the
base unit. Make sure the front of the lid is
placed next to the Elmo face.
When the base is lifted, the lid should
not fall from the bottom of the unit.
Place waste tub into the base unit. It
will only fit into the base with the handle
facing the back of base unit.
6
1
2
2
3
Continued on next page
Front of Lid
Bottom of Lid
Short Anti-Skid
Gripper
Short Anti-Skid
Gripper
Long Anti-Skid
Gripper
SESAME STREET
3
4
5
5
4
Insert the seat into the base by sliding
the four tabs into the slots.
Insert the deflector shield by sliding
the deflector into the slots on the seat
as shown. Use the deflector shield as
needed; recommended for boys.
Press Elmo’s hand to hear Elmo say fun,
encouraging phrases.
8
7
6
6
7
8
Elmo’s Hand
How to Use on an Adult Toilet
1
When your child is ready to use an adult
toilet, the seat will transfer to most adult
toilets. For your child’s safety, do not use
potty seat on padded or cushioned toilet
seats.
Remove the potty seat by lifting upward.
Place the seat on the adult toilet
ensuring that the tabs fit inside the
rim of the toilet. Make sure the seat is
level on the toilet and fits snugly within
toilet seat opening without tipping,
before child uses. Insert deflector shield
as needed.
2
2
1
7
Remove the potty seat and deflector
shield and store for future use.
The waste tub may be left inside the
base unit while using the step stool
feature.
Pull lid from under base unit, to remove
from unit. Tilt lid as needed, to remove.
Line up the front of the lid to the front of
the base unit and insert tabs into the
slots as shown. The lid's tabs will only fit
into the base in one direction. Do not
force the tabs.
IMPORTANT: Turn the electronics off
( O ) when using the step stool feature.
4
1
3
4
8
How to Convert to a Step Stool
1
2
3
9
Remove lid and store under the unit.
See page 6 for details.
Insert potty seat tabs into the slots on
top of the base.
CAUTION: DO NOT use seat as a step
stool.
How to Convert from Step Stool to Potty
2
1
2
1
How to Clean the Unit
Remove the potty seat by lifting upward and
clean with soap and water as needed.
Remove the waste tub by lifting upward on
the rear handle and empty. Clean with soap
and water.
DO NOT immerse the base unit into water
for your safety and to avoid damaging the
electronic unit. Wipe the main base unit with
a cloth instead.
1
2
3
3
Have fun rewarding your child for his or
her progress with the mini-book and 20
colorful Sesame Street stickers.
Write child’s name in the book and keep
nearby to encourage and reward the
child for potty training achievements.
Allow the child to place the stickers onto
the stars in the book as he or she
becomes a potty training all-star.
Additional books and stickers are
available through Consumer Services.
See page 31 for details.
Reward Book & Stickers
1
1
2
2
Sesame Workshop®, Sesame Street®, Sesame Beginnings™, and associated characters,
trademarks and design elements are owned and licensed by Sesame Workshop.
© 2007 Sesame Workshop. All rights reserved.
Kolcraft
®
warrants this product to be free of defects in materials and workmanship, as follows:
For a period of ONE YEAR from the date of purchase, Kolcraft will repair or replace, at its
option, the defective product. If you have a problem or are not satisfied with this product,
please contact the Consumer Service Department at Kolcraft.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE
REMEDY OF THE CONSUMER. KOLCRAFT SHALL NOT BE LIABLE FOR ANY INCIDENTAL
OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY
ON THIS PRODUCT, EXCEPT TO THE EXTENT REQUIRED BY APPLICABLE LAW. ANY
IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE
ON THIS PRODUCT IS LIMITED TO THE DURATION OF THIS WARRANTY.
Some states do not allow the exclusion or limitation of warranties set forth above, so the
above exclusions may not apply to you. This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state. We sincerely thank you for your
purchase of this Kolcraft product.
To obtain warranty service, please call Kolcraft’s Consumer Service Department at
1-800-453-7673 in U.S. and Canada, 1-910-944-9345 outside U.S. and Canada or contact us
via email at customerservice@kolcraft.com
If the product is returned to Kolcraft’s Consumer Service Department for repair or
replacement, it must be shipped prepaid and adequately insured.
For further information visit www.kolcraft.com
Recall WEBSITE
: HELP KEEP YOUR CHILD SAFE. Check www.recall.gov to see if any
products you use with your child or any of your child's toys have been recalled.
10
Personal Record Card
Once in a while, we are less than perfect and one of our products reaches a customer with a
problem. In most cases, we can solve your problem with replacement parts. Please contact
us before you return one of our products to the store. Once a product is returned, it cannot
be resold. The materials and the energy used to make it are wasted.
Please fill in the information in the space provided and attach a copy of your purchase
receipt. You will need this information to obtain warranty service.
You can find the Model Number and Date of Manufacture stickered to the inside back of the
base unit.
Please direct any comments, questions or replacement part requests to:
Kolcraft®Enterprises, Inc. Consumer Service Department
10832 NC Highway 211East
Aberdeen, NC 28315
1-800-453-7673 in U.S. & Canada, 1-910-944-9345 outside U.S. & Canada
Eastern Standard Time, 8 am-6:45 pm Monday - Thursday, 8 am-3:30 pm Friday
fax: 910-944-3536
e-mail: customerservice@kolcraft.com
Model / Style Number: __________________________
Date of Manufacture:____________________________
Date of Purchase: _______________________________
Limited Warranty
Turn to page 31 to see a list of
replacement parts
Loading...