Kolcraft S67-T User Manual

Contours™Lite Series Stroller Instruction Sheet

Hoja de instrucciones para Contours

™

Lite carriola

Feuille d’instructions pour la poussette compacte Contours

™

Avoid serious injury from falling or sliding out. Always use Restraint System. Your child's safety depends on you. Proper stroller use cannot be assured unless you follow these instructions. DO NOT USE STROLLER UNTIL YOU READ AND UNDERSTAND THESE INSTRUCTIONS.

IMPORTANT SAFETY INFORMATION:

How to Keep Your Child Safe While Using this Stroller

•

Assembly by Adult Required.

• NEVER LEAVE YOUR CHILD UNATTENDED WHILE IN STROLLER. Accidents can happen quickly while your back is turned. You must always keep your child in view while your child is in the stroller, even when sleeping. Do not use this product as a bed. Your child may become tangled in straps or pads and suffocate.

• Always use restraint system to keep child from standing up or falling out of the stroller. Do not use product without full 5-point Harness Restraint. Removing the shoulder straps will not adequately restrain child.

• Always lock the stroller open before allowing your child in or near the stroller. This prevents injuries caused by stroller collapsing.

• Only use this stroller with children who weigh less than 35 lbs. (15.8 kg) or are less than 40” (1 meter) tall. Use by larger children may damage the stroller, or cause a hazardous unstable condition to exist.

•

Use this stroller in the reclined position until child can sit up unassisted.

• Always set the wheel brakes when stroller is not moving, especially on an incline. This prevents the stroller from rolling away.

• Always fasten the canopy onto the seat back when using the stroller in the reclined position.

What to Avoid While Using this Stroller

• Always balance the weight of the stroller evenly. To prevent the stroller from becoming unstable or tipping:

•Do not place parcels or accessory items on the stroller canopy,

seat, or over the handle.

•Do not put more than 10 lbs. (4.54 kg) in the basket.

•Do not allow children to play with or hang onto the stroller.

WARNING

Continued on next page

• Never use this stroller on stairways or escalators.

• DO NOT lift by tray.

• Make sure children are clear of any moving parts if you adjust the stroller, otherwise they may be injured.

• This is not an exercise stroller!

Do not use this product while running,

jogging, in-line skating or participating in other athletic activities.

• DO NOT put child in basket.

•

DO NOT use any infant car seats with this product. Serious injury could occur.

• Take care when folding and unfolding to prevent finger pinching.

• Product may become unstable if a parcel bag, other than the one recommended by the manufacturer is used.

• DO NOT allow children to climb into stroller unassisted. Stroller may tip over and injure child.

• Only use replacement parts supplied by the manufacturer.

To Open Stroller

Remove any cardboard inserts or plastic ties used to protect the product during shipment.

Unfold, making sure both side locks snap into place as shown.

Parts List

How to Assemble Your Stroller

Stroller Frame Front Wheel

Assembly (2)

Rear Axle Assembly

Rear Wheels

(2)

Front Tray

Washers

(2)

Cotter Pins

(2)

Hub Caps

(2)

Cup Holder

(select models)

Side Lock

Infant Head Roll

(select models)

iPod®Mini

Adapter

(select models)

Thick iPod

Protection Pad

(select models)

Thin iPod

Protection Pad

(select models)

iPod®Dok

(select models)

To Assemble Front Wheels

Place stroller back on handle bars.

Locate “▲” and “★” underneath

Front

Wheel Assembly

. Align assembly with

front axle and snap into place as shown.

Repeat for other Front Wheel Assembly. Tug firmly on each wheel assembly to be sure wheels are securely in place.

NOTE: To remove, push spring loaded button in and pull off wheel.

Left ★

Right ▲

To Assemble Rear Wheels

Turn stroller over as shown.

Position

Rear Axle Assembly

as shown, with red brake levers pointing towards stroller handle.

Push Rear Axle Assembly onto rear leg tubes at the same time.

Make sure plastic tabs on rear axle lock into holes on rear legs as shown.

Slide a

Rear Wheel

onto the axle then

slide a

Washer

onto the axle.

Fit straight part of

Cotter Pin

through

hole on axle as shown.

Line up each of the tabs in the

Hub Cap

with the slots in the wheel, snap Hub Cap into place.

Repeat for second side.

1 & 2

Tab locks into hole

To Attach Front Tray

Align

Front Tray

in holes located on seat

frame.

Snap tab in place until a click is heard.

Repeat for second side.

TO ROTATE OR REMOVE TRAY: Push in button located near side housing and pull tray out. Repeat on other side, to remove tray completely.

Release Button

To Attach Cup Holder (select models)

Attach

Cup Holder

to right handle by aligning hole over pins and snap into place.

TO CLEAN: Top rack dishwasher safe.

WARNING

Do not place more than 1 lb (0.45 kg) in this cup holder to avoid tipping.

Do not place hot liquids in this cup holder. Hot liquids can burn your child.

Align plastic seat plug with hole on side housing, push to snap into place.

Repeat for other side.

To Attach Seat Pad to Frame

To Assemble iPod

Dok (select models)

Determine which iPod®model you own (iPod®mini, 60GB iPod®, 40GB iPod®, 30GB iPod®or the 20GB iPod®). See www.apple.com for assistance in determining which model you have.

If you own the iPod®mini, proceed to Step 3. For all other models, remove the iPod®mini adapter by flexing the snap tab and pulling up on the adapter.

Release the snap that holds the iPod

Dok in the closed or portable position.

Select the proper donut-shaped protection pad for your iPod®. For the mini, 30GB or 20GB iPod®, select the thick donut-shaped protection pad with yellow backing paper. For the 60GB or 40GB iPod®, select the thin donut-shaped protection pad with white backing paper. Remove the backing paper from the foam, and place the adhesive side of the foam pad onto the back of the speaker housing.

Insert your iPod®into the iPod®Dok or insert your iPod®mini into the iPod

adapter. Insert the speaker Jack into your iPod®device.

For use on a flat surface such as a table top, rest the iPod

Dok on the surface in the open position. For portable use with your stroller, push the speaker housing and the iPod®cradle together until you hear a snap. DO NOT turn the iPod

Dok upside down, unless the Dok is in the closed or latched position.

Power and volume of the iPod

Dok are controlled through your iPod®device. Turn on your iPod®and adjust the volume of your iPod®to a desired level.

NOTE: Song volume and clarity will vary with the quality of the song data that you downloaded to your iPod®.

WARNING

DO NOT turn the iPod®Dok upside down, unless the Dok is in the closed and latched position. iPod®could fall out.

To Secure Child In Stroller

Lock both foot brakes to keep stroller from rolling.

Place child in stroller.

Hook shoulder straps to waist belt.

To fasten restraint system buckles - push together. Be sure both buckles are fastened to secure child safely.

To unsnap restraint system buckles press tabs to release.

For proper fit, adjust shoulder straps and waist band as shown.

WARNING

Avoid serious injury from falling or sliding out. Always use restraint system. Do not use product without full 5-point Harness Restraint. Removing the shoulder straps will not adequately restrain child.

Adjust Restraint System Harness

How to Properly Use Your New Stroller

To Operate Brakes

Push levers on both rear wheels down to lock.

Pull levers up to unlock.

Unlock

Lock

NOTE: For a secure fit, straps should be at or below the child's shoulder. Adjust straps to higher position as your child grows.

To readjust shoulder restraints, unbuckle back of seat and push buckle back through slot.

Position buckle to higher position and push buckle through slot as shown. Repeat for second side.

From the back side of the stroller, fasten buckles together to secure restraint.

To Adjust Shoulder Strap Height

Lower Higher

To Recline Seat

To recline seat back, loosen belt.

To raise seat back, tighten belt.

WARNING

To avoid finger entrapment or pinching, do not adjust the seat back while child is in the stroller. To avoid head entrapment, always fasten the canopy to the seat back when using the stroller in the reclined position.

Tighten

The infant head roll is to be used with newborns who can not hold up their head. It should be used only when the seat is reclined. It can be removed when a child can hold their head up unassisted.

When using the infant head roll, be sure that the shoulder restraint straps are fed through the holes on either side. Restraint must always be used with the infant head roll.

To Install Infant Head Roll (select models)

To Insert iPod Dok to Canopy (select models)

Insert iPod Dok into the pocket provided on the stroller canopy with the speaker facing the mesh or toward the child seat.

Ensure that the cover for the pocket is securely latched by the Velcro.

CAUTION

Loud volume can damage your baby’s hearing. When turning on music, gradually adjust the volume to a comfortable listening level so baby’s not startled.

Care & Maintenance

• To keep your stroller running smoothly and avoid squeaking wheels use a silicon or graphite based lubricant. It is important to get it into the axle and the wheel assembly.

• Clean metal parts with a damp cloth and wipe dry.

• Clean woven fabric or vinyl parts with mild soap and water solution.

• Dry wet stroller with a soft cloth to prevent rusting.

• When storing stroller, never stack other items on top of it; this may damage the stroller.

• Periodically check for worn parts, loose screws, torn materials or stitching.

• Replace any damaged parts immediately.

**iPod is a registered trademark of Apple Computer, Inc. Apple Computer, Inc. is not associated with Kolcraft

Enterprises, Inc. and no approval by

them is to be implied.

To Fold Stroller

BEFORE FOLDING: Lock brakes.

Close canopy.

Pull up latches on frame to fold and push forward.

Fold as shown.

Engage locking latch.

+ 25 hidden pages