Kolcraft baby's 1st jeep Instruction Manual

READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE OF PRODUCT.

Failure to follow warnings and instructions could result in injury or death to your child.

Make sure rocker is fully assembled and secure before use.

Keep these instructions for future reference.

R02J-A 3/03

1

R02J-A

B

ABY’S

1ST JEEP® ROCKER INSTRUCTIONS

! !

WARNING

• STOP using rocker when your child is 36 months or weighs more than 45 lbs (20.41 kgs).

• To prevent injury from falls:

• NEVER leave your child unattended.

• NEVER use on any elevated surface.

•ALWAYSuse restraint until child is able to climb in and out of the chair unassisted.

• Use the upright position only when child can sit up unassisted.

• NEVER lift rock er while child is seated.

• DO NOT lift by to y bar.

• NEVER use rock er as a car seat;it will not protect your baby during an accident.
A

VOID STRANGULATION HAZARDS:

• DO NO T place items with a string around child’s neck (pacifier cords,hood strings,etc.).

• DO NOT allow strings to hang into bouncer, including blind cords or suspended toys other than

what is provided with this product.

• DO NOT use around pets or other children.

• DO NOT continue using infant rocker if it becomes bent,broken or if the cloth cover is
ripped or torn.

© 2003 Kolcraft®Enterprises,Inc. All rights reserved.

Frame

Toy Bar

Seat Pad

Infant Headrest

by

PARTS LIST:

R02J-A 3/03

2

Step 1.

Insert a flat head
screwdriver tip into battery door
located underneath vibrator. Release
tab,and gently push tab back and
up to release.

Step 2. Insert “C” cell battery as

shown.

Step 3. Replace battery cover

making sure tabs snap securely
into place.

Step 4.

Slide button to “on” posi­tion to activate vibrating mecha­nism.

Step 5. Slide button to “off”

position to stop vibrating motion.

54

Remove battery before
storing the product for a
prolonged period of time.

CAUTION

! !

1

2

Step 1. To open frame,hold top

of frame and pull the wire lever until
rocker is open.

Step 2. Slip seat pad onto back of

frame making sure release handle fits
through opening.

Step 3. Zip the seat pad to secure

to frame.

1

TO INSTALL BATTERIES IN

VIBRATOR:

2

T O ASSEMBLE FRAME:

How To Assemble Y our Rocker