Kolcraft AQ600 User Manual

3-in-1 Convertible Crib
Conversion Kit Assembly Instructions

Lit de bébé 3-en-1
Instructions d'assemblage pour la trousse de conversion

Cuna 3-en-1
Instrucciones de montaje para el juego de conversión

WARNING

For conversion to a toddler bed or daybed, this toddler/daybed conversion kit must be used.
See Instructions.

AVERTISSEMENT

Pour la conversion en un lit d'enfant ou lit de repos, ce kit de conversion doit être utilisé.
Voir les instructions.

ADVERTENCIA

Para la conversión a una o , se debe utilizar este kit de conversión..
Vea las Instrucciones.

cama de bebé cama de día

Q018

End

Side

Undo 3 screws on
each side

High Position

Middle Position

Low Position

Thread and tighten

all four screws

Mattress Support

Should be set to lowest position

This product works with multiple cribs- illustrations may vary from your model

Step 1:

A. Undo the six screws attaching the Side to the Ends and remove the side.
B. If it is not already, adjust the Mattress Support to its lowest position by loosening the

four screws on the support arms, moving them to the low position holes, and tightening all
four screws.

Thread and tighten 3 screws
on each side

Outer Frame

Step 2:

A. Insert the Outer Frame into the space where the crib side was removed and align the

screws with the holes.

B. Tighten all six screws.
C. To use the crib as a day bed, stop at this step.

Thread and tighten
(both sides)

Outer Frame

Guard Rail

Step 3:

A. To use as a toddler bed, put the Guard Rail inside the Outer Frame and align the screws.
B. Tighten all four screws on the Guard Rail securely with the allen wrench.