Kolcraft 46252 Owner's Manual

Universal 2 Car Seat Carrier Instruction Sheet

Carriola Universal 2 para asientos de automóvil

Mode d’emploi du Châssis Siège Auto Universal 2

Failure to follow these instructions could result in serious injury or death. Your child’s safety depends on you. Proper Carrier usage cannot be assured unless you follow these instructions. DO NOT USE CARRIER UNTIL YOU READ AND UNDERSTAND THESE INSTRUCTIONS.

IMPORTANT SAFETY INFORMATION:

How to Keep Your Child Safe While Using this Carrier

•

Adult Assembly Required.

• AVOID SERIOUS INJURY FROM FALLING OR SLIDING OUT:

• This product is only to be used with certain Infant Car Seats. See list on Page 3 for compatible Infant Car Seats.

• When using this product, infant must always be secured in the car

seat with the car seat harness and car seat secured with red

restraint strap.

• DO NOT fill basket above warning strap. Car Seat can become unstable if items in basket touch Car Seat.

• NEVER LEAVE YOUR CHILD UNATTENDED WHILE IN CARRIER. Accidents can happen quickly while your back is turned. You must always keep your child in view while your child is in the Carrier, even when sleeping. Your child may become tangled in the Infant Car Seat or Carrier straps or pads and suffocate.

• Always balance the weight of the Carrier evenly. To prevent the Carrier from becoming unstable or tipping:

• Do not allow tray to lift Infant Car Seat. Car Seat must rest on front & rear bars for proper installation.

• Do not place parcels or hang accessory items on the Carrier,

Infant Car Seat, or over the handle.

• Do not put more than 10 lbs (5.44 kg) in the basket.

• Do not allow children to play with or hang onto the Carrier.

• Make Sure the Carrier is fully unfolded and securely latched before attaching your Infant Car Seat. This prevents finger pinching and injuries caused by the Carrier collapsing.

• Only transport infants that are within the size and weight limitations of your Infant Car Seat, as described in the instruction manual provided by the Infant Car Seat manufacturer.

•

DO NOT carry additional children, goods or accessories in or on this carrier except as permitted in these instructions.

WARNING

Continued on next page

• To ensure your Infant Car Seat is properly installed on the carrier, make sure it is:

• Facing the person pushing the carrier.

• Tightly secured to the carrier with the red restraint straps.

• If at any time your Infant Car Seat does not secure properly to the

carrier, or if you have questions about assembly or use of the carrier, Do Not use this product. Call Kolcraft at 1-800-453-7673.

• Always set the wheel brakes when Carrier is not moving, especially on an incline. This prevents the Carrier from rolling away.

• Make sure children are clear of any moving parts if you adjust the stroller, otherwise they may be injured.

• Take care when folding and unfolding to prevent finger pinching.

• Product may become unstable if a parcel bag, other than the one recommended by the manufacturer is used.

• Never use this Carrier on stairways or escalators.

• DO NOT lift Carrier by bars or by secured Infant Car Seat.

• This is not an exercise Carrier! Do not use this product while running, jogging, in-line skating or participating in other athletic activities.

• DO NOT put child in basket.

• THE FOLLOWING INFANT CAR SEATS CAN BE USED IN THIS CARRIER:

If your Infant Car Seat is not one of the models listed above, DO NOT use this Carrier. Other Infant

Car Seat models will not attach properly to

the Carrier and may result in serious injury to your child.

• DO NOT USE THE FOLLOWING CAR SEATS IN THIS

CARRIER

! This

list is not inclusive:

Baby Trend®, Britax®, Century®, Combi®, Cosco®, EvenFlo®, Graco®, Peg Pérego®and Safety 1st®are trademarks of their respective owners. They are not associated with Kolcraft Enterprises, Inc. and no approval by them is to be implied.

•Cosco®Eddie Bauer®Caress

•Cosco

Eddie Bauer

Opus®35

•Cosco®First Ride DX

•Cosco

Turn-A-Bout

•Evenflo®Cozy Carry

™

•Evenflo®Discovery

™

•

Evenflo®On-My-Way

™

•Britax®Companion

•Britax®Handle with Care

•Century®Avanta™Series

•

Century®Vanté™5

•Combi®Connection

™

•

Combi®Ty ro

™

•

Cosco®Arriva®Series

•

Cosco®Designer

•

Evenflo®Portabout

™

•

Graco®Safe Seat

™

•

Graco®Snug Ride™Series

•

Peg Pérego Primo Viaggio SIP

•

Safety 1st®Designer®22

™

•

Safety 1st®Starter

™

•Baby Trend®Latch-Loc

•Baby Trend

Flex-Loc

•Britax

Baby Safe

™

•Century®535/580/590 Series

•Century

Assura®Series

•Century

Smart Fit™Series

•Chicco

Key Fit

•

Cosco®Dream Ride

•

Fisher Price®Stay in View

™

•Evenflo®Embrace

™

•All Gerry®Infant Car Seats

•

Peg Pérego Primo Viaggio

•Kolcraft®Infant Rider

•Kolcraft®Secura™

To Open Carrier

Release locking latch.

Unfold as shown. Make sure both locks click into place.

Press down on each lock to ensure you have carrier properly locked in position.

Parts List

How to Assemble Your Carrier

Front Wheels (2)

Parent TrayBasket

Stroller Frame

Rear Wheels (2)

Washer (2) Cotter Pin (2) Hub Cap (2)

Rear Axle

Tab

To Assemble Front Wheels

Remove any cardboard inserts or plastic ties used to protect the product during shipment.

Tur n

Carrier

over as shown.

Align front wheel assembly as shown. Tab must be facing away from pin (towards you).

Push wheel assembly onto pin until it snaps into place.

Repeat for other wheel. Tug firmly on each wheel assembly to be sure assemblies are securely in place.

NOTE: To remove front wheels, pull tab and lift wheel off.

Position complete rear axle assembly with brakes as shown, with brake levers pointing towards Carrier handle.

Push both brake assemblies onto rear leg tubes at the same time.

Make sure plastic tabs on brake assemblies lock into holes on rear legs as shown.

Line up tabs in each of the hub caps with slots in the wheel, snap hub caps into place.

To Assemble Rear Wheels

Tab locks into hole

To Attach Parent Tray

WARNING

Do not place more than 3 lbs. (1.36 kg) in this tray to avoid tipping! Do not place hot liquids in this tray. Hot liquids can burn your child.

To assemble parent tray. Align tray holes with posts near handle and snap on.

To remove parent tray, pull each side up and out.

How to Properly Use Your New Carrier

To Operate Brakes

Push levers on both wheel assemblies down to lock.

Pull levers up to unlock.

WARNING

DO NOT fill basket above warning strap. Infant Car Seat can become unstable if items in basket touch Infant Car Seat. Maximum basket weight 10 lbs. (5.44 kg)

To Secure Infant Car Seat

Lock both foot brakes to keep stroller from rolling.

To fasten car seat restraint belts - open up loop of the restraint belt. Adjust belt until the buckles almost touch.

Pull end tab of restraint belt to set. Push buckles together to secure.

To unsnap Restraint Belt - press tabs.

Unlock

Lock

To secure your Britax

Handle with Care®Infant Car Seat

•When using this product, to avoid serious injury from falling or sliding out, infant must always be secured in the Infant Car Seat with the Car Seat harness. Refer to Infant Car Seat Instructions for proper adjustment.

•Do not allow tray to lift car seat. Car Seat must rest on front & rear bars for proper installation. Failure to follow these instructions could result in serious injury.

Rear Bar

Front Bar

WARNING

Front Bar

Rear Bar

Britax

Tray

Continued on next page

Adjust tray to its lowest position. To adjust, pull knob out and twist.

With one hand, grasp the Infant Car Seat handle (in its upright, carrying position). With your other hand, grasp Infant Car Seat near baby’s feet. Gently position the Infant Car Seat above

Carrier

so the

baby faces the handle.

Place rear rocker of the Infant Car Seat underneath the front bar as shown.

Gently place front portion of Infant Car Seat Rocker underneath the rear bar.

Raise tray until it touches the bottom of the car seat. Do not allow tray to lift Car Seat.

3 & 4

Knob

Secure Car Seat to

Carrier

by feeding Restraint Straps through Infant Car Seat belt slots and buckle. Tighten Restraint Straps.

NOTE: Your Infant Car Seat may have a level indicator. It is not necessary for use with this carrier and the indicator may fall outside the recommended area. The level indicator is for use while the Infant Car Seat is in an automobile.

Make sure Infant Car Seat is secure. Test Infant Car Seat installation by moving it in all directions to ensure a tight fit to

Carrier

TO REMOVE CAR SEAT

Unbuckle Restraint Straps and remove them from Car Seat belt slots.

With one hand grasp the Infant Car Seat handle (in its upright, carrying position).

With your other hand, grasp Infant Car Seat near baby’s feet. Gently pull up on the front portion of Infant Car Seat and remove.

Rear Bar

Restraint Straps

Front Bar

To Secure All Other Acceptable Infant Car Seats

Adjust tray to its lowest position. To adjust, pull knob out and twist.

With one hand, grasp the Infant Car Seat handle (in its upright, carrying position). With your other hand, grasp Infant Car Seat near baby’s feet. Gently position the Infant Car Seat above

Carrier

so the

baby faces the handle.

Lower the Infant Car Seat between the front & rear bars.

Raise tray until it touches the bottom of the car seat. Do not allow tray to lift Car Seat.

Rear Bar

Continued on next page

Front Bar

•Do not allow tray to lift car seat. Car Seat must rest on front & rear bars for proper installation. Failure to follow these instructions could result in serious injury.

WARNING

Front Bar

Rear Bar

Tray

Knob

Secure Car Seat to

Carrier

by feeding Restraint Straps through Infant Car Seat belt slots and buckle. Tighten Restraint Straps.

NOTE: Shopping cart lever will not lock onto the carrier. To secure infant car seat to carrier, use restraint straps.

Special Instructions

for Car Seats without

belt slots: Secure Infant Car Seat to

Carrier

by bringing Restraint Straps over the sides of the seat near the base of the seat handle and buckle them together. Tighten Restraint Straps.

Make sure Infant Car Seat is secure. Test Infant Car Seat installation by moving it in all directions to ensure a tight fit to

Carrier

TO REMOVE CAR SEAT

Unbuckle Restraint Straps and remove them from Car Seat belt slots.

With one hand grasp the Infant Car Seat carry handle (in its upright, carrying position).

With your other hand, grasp Infant Car Seat near baby’s feet. Gently pull up on the front portion of Infant Car Seat and remove.

NOTE: Some Infant Car Seats

may

lock on, but not on all car seats. With your other hand, press back shopping cart lever on Adjustment Bar.

Note: Shopping Cart Lever

Rear Bar

Restraint Straps

Front Bar

Care & Maintenance

To Fold Carrier

Lock brakes.

Push red button with thumb, then press red lever under handle.

NOTE: If 1-hand fold feature does not operate properly, pull up latches on frame to fold.

Fold

Carrier

NOTE: Fold

Carrier

so wheels straddle frame. DO NOT allow wheels to press against frame as this may damage tires.

Engage locking latch.

• To keep your stroller running smoothly and avoid squeaking wheels use a silicon or graphite based lubricant. It is important to get it into the axle and the wheel assembly.

• Clean metal parts with a damp cloth and wipe dry.

• Clean woven fabric or vinyl parts with mild soap and water solution.

• Dry wet stroller with a soft cloth to prevent rusting.

• When storing stroller, never stack other items on top of it; this may damage the stroller.

• Periodically check for worn parts, loose screws, torn materials or stitching.

• Replace any damaged parts immediately.

+ 27 hidden pages