Kohler K-13688, K-13691, K-13689, K-13690, K-13692 Installation And Care Manual

Installation and Care Guide

Rain Showerheads

K-13688, K-13689, K-13690,
K-13691, K-13692, K-13693,
K-13694, K-13695, K-13696,

K-45200, K-45201, K-45202

M product numbers are for Mexico (i.e. K-12345M)
Los números de productos seguidos de
M corresponden a México (Ej.
K-12345M)

1141989-2-E

Tools

Plumbers
Putty

Sealant
Tape

Strap
Wrench

Thin Bladed
Screwdriver

Important Information

NOTICE: Choose an automatic compensating valve with the
appropriate minimum flow rating to ensure your valve will provide
safety at the lowest flow rates.

For a showerhead rated at 2.5 gal/min (9.5 l/min) maximum, use
with an automatic compensating valve rated at 2.0 gal/min (7.6
l/min) or less.

For a showerhead rated at 2.0 gal/min (7.6 l/min) maximum, use
with an automatic compensating valve rated at 1.6 gal/min (6.1
l/min) or less.

Observe all local plumbing and building codes.

NOTE: For service parts information, visit your product page at
www.kohler.com/serviceparts.

1141989-2-E 2 Kohler Co.

WallCeiling

Apply sealant tape.

Elbow

Apply
sealant tape.

Apply
plumbers putty.

Flange and
Setscrew
(not included)

Shower Arm
(not included)

Showerhead

Install the Showerhead

NOTE: The shower arm with flange are not provided.

Remove the existing showerhead and shower arm, if applicable.
Install the shower elbow. Make sure the elbow is securely

mounted and has adequate strength to support the showerhead.
Apply a bead of plumbers putty or other sealant to the back of

the flange.
Place the flange onto the long end of the shower arm, as

illustrated.
Apply sealant tape to the threads of each end of the shower arm.
Install the shower arm to the shower elbow.
Use a clean strap wrench to tighten the arm onto the elbow.
Press the flange against the finished wall/ceiling.
Secure the flange to the shower arm by tightening the setscrew.
Remove any excess putty.
Turn on the water to flush any debris through the shower arm.
Turn off the water.
Handtighten the showerhead to the shower arm.
Use a clean strap wrench to completely tighten the showerhead.
Check all connections for leaks.

Kohler Co. 3 1141989-2-E

Clean the Spray Holes

To dislodge debris and mineral build-up:

Run water through the showerhead.
Firmly rub your finger back and forth across the spray holes in

the showerhead face.
If this procedure fails to improve the performance of the

showerhead, proceed to the ″Clean the Screen Washer″ section of
this guide.

1141989-2-E 4 Kohler Co.

Screen Washer

Inlet

Showerhead

Apply thread sealant.

Clean the Screen Washer

Use a clean wrench to remove the showerhead from the shower
arm; be careful not to mar the finish.

Use a thin bladed screwdriver to carefully pry up the edge of the
screen washer. Remove and clean the screen washer.

NOTE: Do not attempt to remove the flow control.

Reinstall the screen washer with the tapered end out.
Apply sealant tape to the threads of the shower arm.
Reinstall the showerhead.

Care and Cleaning

For best results, keep the following in mind when caring for your
KOHLER product:

•

Use a mild detergent such as liquid dishwashing soap and warm
water for cleaning. Do not use abrasive cleaners that may scratch
or dull the surface.

•

Carefully read the cleaner product label to ensure the cleaner is
safe for use on the material.

•

Always test your cleaning solution on an inconspicuous area
before applying to the entire surface.

•

Do not allow cleaners to sit or soak on the surface.

Kohler Co. 5 1141989-2-E

Care and Cleaning (cont.)

•

Wipe surfaces clean and rinse completely with water immediately
after cleaner application. Rinse and dry any overspray that lands
on nearby surfaces.

•

Use a soft, dampened sponge or cloth. Never use an abrasive
material such as a brush or scouring pad to clean surfaces.

For detailed cleaning information and products to consider, visit
www.kohler.com/clean. To order Care & Cleaning information, call
1-800-456-4537.

Warranty

KOHLER®Faucet Lifetime Limited Warranty

Kohler Co. warrants its Faucets* manufactured after January 1, 1997, to
be leak and drip free during normal residential use for as long as the
original consumer purchaser owns his or her home. If the Faucet
should leak or drip during normal use, Kohler Co. will, free of charge,
mail to the purchaser the cartridge necessary to put the Faucet in good
working condition. This warranty applies only to Kohler Faucets
installed in the United States of America, Canada or Mexico (″North
America″).

Kohler Co. also warrants all other aspects of the faucet or accessories
(″Faucet″)*, (except gold, non-Vibrant
of defects in material and workmanship during normal residential use
for as long as the original consumer purchaser owns his or her home.
This warranty applies only to Kohler Faucets installed in North
America. If a defect is found in normal residential use, Kohler Co. will,
at its election, repair, provide a replacement part or product, or make
appropriate adjustment. Damage to a product caused by accident,
misuse, or abuse is not covered by this warranty. Improper care and
cleaning will void the warranty**. Proof of purchase (original sales
receipt) must be provided to Kohler Co. with all warranty claims.
Kohler Co. is not responsible for labor charges, installation, or other
incidental or consequential costs. In no event shall the liability of
Kohler Co. exceed the purchase price of the Faucet.

If the Faucet is used commercially or is installed outside of North
America, or if the finish is gold, non-Vibrant or a painted or powder
coated color finish, Kohler Co. warrants the Faucet to be free from
defects in material and workmanship for one (1) year from the date the
product is installed, under Kohler Co.’s standard one-year limited
warranty.

If you believe that you have a warranty claim, contact Kohler Co.,
either through your Dealer, Plumbing Contractor, Home Center or

, non-chrome finishes) to be free

®

1141989-2-E 6 Kohler Co.

Warranty (cont.)

E-tailer, or by writing Kohler Co., Attn.: Customer Care Center, 444
Highland Drive, Kohler, WI 53044, USA. Please be sure to provide all
pertinent information regarding your claim, including a complete
description of the problem, the product, model number, color, finish,
the date the product was purchased and from whom the product was
purchased. Also include your original invoice. For other information,
or to obtain the name and address of the service and repair facility
nearest you, call 1-800-4-KOHLER (1-800-456-4537) from within the
USA and Canada, and 001-800-456-4537 from within Mexico, or visit
www.kohler.com within the USA, www.ca.kohler.com from within
Canada, or www.mx.kohler.com in Mexico.

KOHLER CO. AND/OR SELLER ARE PROVIDING THESE
WARRANTIES IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO
THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE. KOHLER CO. AND/OR
SELLER DISCLAIM ALL LIABILITY FOR SPECIAL, INCIDENTAL
OR CONSEQUENTIAL DAMAGES. Some states/provinces do not
allow limitations of how long an implied warranty lasts or the
exclusion or limitation of such damages, so these limitations and
exclusions may not apply to you. This warranty gives the consumer
specific legal rights. You may also have other rights that vary from
state/province to state/province.

This is Kohler Co.’s exclusive written warranty.

*Trend
components; WaterHaven®tower, systems and components; Tripoint

faucets, MasterShower®tower, BodySpa systems and

®

®

faucets, Polished Gold, non-Vibrant and painted or powder coated
finishes, fittings; all items within the ″Fixture Related″ section of the
Kohler Faucets Price Book, drains, Duostrainer

sink strainers,

®

soap/lotion dispensers, MoxieTM Wireless Speaker; and faucets used in
commercial settings, and outside North America, are covered by
Kohler Co.’s one-year limited warranty.

**Never use cleaners containing abrasive cleansers, ammonia, bleach,
acids, waxes, alcohol, solvents or other products not recommended for
chrome. This will void the warranty.

Kohler Co. 7 1141989-2-E

Guide d’installation et d’entretien

Pommes de douche Pluie

Outils

Mastic de
plombie

d'étanchéité

Clé à sangleRuban

Tournevis à tête
plate et fine

Informations importantes

AVIS: Choisir une vanne de compensation automatique de débit
minimal approprié pour assurer la sécurité aux débits les plus bas.

Pour une pomme de douche de débit nominal de 2,5 gal/min (9,5
l/min) maximum, utiliser une vanne de compensation
automatique d’un débit nominal de 2,0 gal/min (7,6 l/min) ou
moins.

Pour une pomme de douche de débit nominal de 2,0 gal/min (7,6
l/min) maximum, utiliser une vanne de compensation
automatique d’un débit nominal de 1,6 gal/min (6,1 l/min) ou
moins.

Respecter tous les codes de plomberie et de bâtiment locaux.

REMARQUE: Pour tout renseignement sur les pièces de rechange,
visiter la page du produit à www.kohler.com/serviceparts.

Kohler Co. Français-1 1141989-2-E