Kohler K-26142-CR, K-27142-CR User Manual

Homeowners Guide

Cleansing Seat

K-

26142-CR, K-27142-CR

Français, page “Français-1”
Español, página “Español-1”

1354689-5-A

IMPORTANT SAFEGUARDS

READ ALL INSTRUCTIONS BEFORE

USING

When using electrical products, especially when children are present,
basic safety precautions should always be followed, including the
following:

IMPORTANT! Risk of product damage. Do not install this product

location

in a
might form on the product surface. Provide adequate ventilation
when bathing to avoid damage to the electronic components due to
high humidity levels.

IMPORTANT! Risk of product or property damage. Pushing or
pulling on the water connection may cause water leakage.

IMPORTANT! Risk of product damage. Do not apply excessive
force to the spray wands.

IMPORTANT! Risk of product damage. In areas where water may
freeze in the pipes, make arrangements to keep the pipes warm.
Any water remaining in the seat may freeze during winter storage.
Allow the unit to warm to room temperature before reinstalling or
using.

exposed to excessive moisture where condensation

IMPORTANT! Risk of product damage. Do not supply electrical
power to the unit until the plumbing installation work has been
completed, as it may cause the product to malfunction.

NOTE: The thermal protectors may trip during storage or

transportation in warm weather causing the unit to not operate.
Allow the unit to cool to room temperature before installation or
operation.

DANGER: To reduce the risk of electrocution:

Do not place or store this product where it can fall or be pulled
into a bath or sink.

Do not place in or drop into water or other liquid.
Do not reach for a product that has fallen into water. Unplug

immediately.

1354689-5-A 2 Kohler Co.

IMPORT

ANT SAFEGUARDS (cont.)

WARNING: To reduce the risk of burns, electrocution, fire,
or injury to persons:

Close supervision is necessary when this product is used by or
near children, the elderly, or invalids. Adjust the temperature of
the seat for the elderly, those who are incapacitated, or persons
with sensitive skin.

Use this product only for its intended use as described in this
manual. Only use attachments recommended by Kohler Co.

Never operate this product if it has a damaged cord or plug, if it
is not working pr
dropped into water. Return the product for examination and
repair.

Keep the cord away from heated surfaces.
Never block the air openings of the product or place it on a soft

surface, such as a bed or couch, where the air openings may be
blocked. Keep the air openings free of lint, hair, and the like.

Never use while sleeping or drowsy.
Never drop or insert any object into any opening or hose.
Do not use outdoors or where aerosol spray products are being

used or where oxygen is administered.
Connect this product to a properly grounded outlet only. See the

“Grounding Instructions” section.
This product conforms to applicable provisions of US 21 CFR,

Chapter

1, Subchapter J, Radiological Health.

operly, if it has been dropped, damaged, or

SAVE THESE INSTRUCTIONS

Kohler Co. 3 1354689-5-A

Grounded
Outlet

Grounding
Plug

Grounding Instructions

WARNING: Risk of electric shock, fire, or personal injury.

This product must be grounded and connected only to a
dedicated, nominal 120 VAC, 60 Hz circuit protected by a
minimum 15 A Ground-Fault Circuit-Interrupter (GFCI) or
Residual Current Device (RCD).

This product should be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This product is
equipped with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is properly
installed and grounded.

DANGER: Risk of electric shock. Improper use of the
grounding plug can result in a risk of electric shock.

If repair or replacement of the cord or plug is necessary, do not
connect the grounding wire to either flat blade terminal. The wire
with insulation having an outer surface that is green with or
without yellow stripes is the grounding wire.

Check with a qualified
grounding instructions are not completely understood, or if in
doubt whether the product is properly grounded.

Do not use an extension cord with this product.

electrician or service personnel if the

1354689-5-A 4 Kohler Co.

AB

C

E

D

Remote Control

J

K

Panel

GH

F

L

M

Remote Control Operation

NOTE: For features with multiple settings, press the icon to move

the setting one level higher. If the feature is set at the highest level,

pressing the icon will deactivate it or adjust it to a lower setting.

NOTE: Make sure that four AA batteries are installed correctly in

the remote control.

A - Preset 1 and

their feature settings. When ″Preset 1″ or ″Preset 2″ are selected,
the saved preferences will activate. Refer to the ″User Presets″
sections below.

B - Battery Indicator: Shows the status of the battery charge.
When the battery is at 100%-50% charge, the icon is off. When the
battery is at 49%-20% charge, the icon flashes for 4 seconds after
the last icon is pushed. When the battery is at 19% or less charge,
the icon glows for 4 seconds after the last icon is pushed.

C - Stop: Press the ″Stop″ icon to stop the front wash, rear wash,
and dryer features.

Preset 2: The presets allow two users to save

Kohler Co. 5 1354689-5-A

Remote

Control Operation (cont.)

D - Front: Pr

ess the ″Front″ icon to activate the fr

ont wash feature

and adjust the front wash water pressure.
E - Rear: Press the ″Rear″ icon to activate the rear wash feature

and adjust the rear wash water pressure.
F - Position: Press the ″Position″ icon to adjust the wand position

when front or rear wash is active. There are three settings.
G - Water Temp: Press the ″Water Temp″ icon to adjust the water

spray temperature. There are three settings.
H - Seat Temp: Press the ″Seat Temp″ icon to activate the heated

seat. Press again to increase the temperature. There are six
settings. When there is no light the heated seat is deactivated.

J - Stop: Press the ″Stop″ icon to stop the front wash, rear wash,
and dryer features.

K - Front: Press the ″Front″ icon to activate the front wash feature
and adjust the front wash water pressure.

L - Rear: Press the ″Rear″ icon to activate the rear wash feature
and adjust the rear wash water pressure.

M - Heating: Press the ″Heating″icon to activate the heated seat.
Press again to increase the temperature. There are three settings.

Setting the User

Presets

NOTE: The presets allow two users to save their feature settings.
When ″Preset 1″ or ″Preset 2″ are selected, the saved preferences
will activate.

While seated, adjust the seat features to your preferences.
Press and hold the ″Preset 1″ or ″Preset 2″ icon for 3 seconds to

save activated features at the current settings.
To change a setting, adjust the front wash, rear wash, or dryer

feature while the preset is in use. Press and hold the ″Preset 1″ or
″Preset 2″ icon for 3 seconds to store the new setting to memory.

Using the User Presets

Press the ″Preset 1″ or ″Preset 2″ icon while you are seated to
activate front wash, rear wash, dryer temperature and speed, and
seat temperature at your stored settings.

If the ″Preset 1″ or ″Preset 2″ icon is pressed while the seat is not
occupied, the seat will gradually (approximately 2 minutes)
change to the preset temperature.

1354689-5-A 6 Kohler Co.

Remote Control Operation (cont.)

To reset or delete a preset, press and hold the ″Preset 1″ or
″Preset 2″ and the ″Stop″ icons at the same time for three

seconds.

Nightlight

To turn off the nightlight, press and hold the ″Stop″ icon for three
seconds.

To disable the nightlight, press and hold the ″Front″ icon for three
seconds.

Pairing a Remote Control

A new remote control must be paired with the seat before use.
Only one remote control can be paired with the seat at a time.
Bring the new remote control near the seat.
Make sure that all other remote controls have been removed from

the area of the seat.
Press and hold the ″Seat Temp″ icon until the icon flashes.
Simultaneously press and hold the ″Front″ and ″Rear″ icons on

the seat until a beep is heard.
When the ″Seat Temp″ icon on the remote control stops flashing

and the ″Preset 1″ and ″Preset 2″ icons are no longer illuminated,
the remote control has been successfully paired with the seat.

Care and Cleaning

For best results, keep the following in mind when caring for your
KOHLER product:

IMPORTANT! Do not immerse product in water.

•

Always test your cleaning solution on an inconspicuous area
before applying to the entire surface.

•

Use a soft, dampened sponge or cloth to wipe surfaces clean.
Remove the cleaner quickly after applying. Rinse and dry any
overspray that lands on nearby surfaces.

•

Do not allow cleaners to soak on surfaces.

•

Never use an abrasive material such as a brush or scouring pad
to clean surfaces.

Kohler Co. 7 1354689-5-A