KOHLER K-113, K-114, K-6822 Installation Manual

Installation Guide

Trip Lever Installation

K-113 K-114

K-6822

M product numbers are for Mexico (i.e. K-12345M)
Los números de productos seguidos de
M corresponden a México (Ej.
K-12345M)
Français, page“ Français-1”
Español, página“ Español-1”

105376-2-BC

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems please don’t
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.

Tools and Materials

Screwdrivers

Before You Begin

NOTE: For ease of installation, change the trip lever before installing
toilet or tank.

Observe all local plumbing codes and building codes.

Kohler Co. reserves the right to make revisions in the design of
trip levers without notice, as specified within the Price Book.

105376-2-BC 2 Kohler Co.

Locknut

Arm

Setscrew

Locknut

Flange

Trip
Lever

Antique
Trip Lever

IV Georges Brass
Trip Lever

Install New Trip Lever

Remove the tank cover from the toilet.

Remove the locknut and trip lever assembly from the toilet.

Install the new flange into the tank hole.

Attach the support to the flange with support arms facing inside
the tank.

Attach the locknut. Tighten hand tight only.

Install the trip lever into the hole of the flange.

While holding the trip lever in a horizontal position, slide the
arm onto the trip lever as far as it will go (the arm should be
positioned between the two prongs of the support).

Tighten the setscrew.

Align the trip lever in horizontal position by rotating the support.

Carefully tighten the locknut to secure assembly to toilet tank.

Hook the flapper ball chain to the hole in the trip arm.

Check for proper chain length and adjust as needed.

Support

StemStem

Kohler Co. 3 105376-2-BC

Install New Trip Lever (cont.)

Check the assembly for smooth operation and flush actuation.
Trip arm movement should be free of interference. The trip lever
should be horizontal when at rest.

Replace the tank cover.

105376-2-BC 4 Kohler Co.