Kogan KASPABWIBZA User manual

IBIZA INFLATABLE PORTABLE OUTDOOR HOT TUB MASSAGE SPA

4-6 PERSONS

KASPABWIBZA

Read all of the instructions before use, and retain this user guide for future reference.

SAFETY INSTRUCTIONS

WARNING!

When installing and using this electrical equipment, basic safety precaution should always be followed, including the following:

Important safety instructions – read and follow all instructions.

WARNING:

• WARNING: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

• Risk of Accidental Drowning: Extreme caution must be exercised to prevent unauthorized access by children. To avoid accidents, ensure that children cannot use this spa unless they are supervised at all times.

• For safety around children and to minimise drowning risk, always fit the spa cover after each use.

• RISK OF INJURY: Do not operate spa if inlet or outlet pipes are broken or missing. Never attempt to replace the inlet and outlet pipes. Contact help.kogan.com for assistance.

• Risk of electric shock: Install at least 2 metres from all metal surfaces.

• Risk of electric shock: Never operate any electrical appliance when in your spa or

when your body is wet. Do not place any electrical appliance (such as a light, telephone, radio or television) within 2 metres of spa.

• TO AVOID ELECTRIC SHOCK, DO NOT USE THE SPA WHEN IT IS RAINING.

• WARNING: Always keep plug dry. NEVER plug or unplug with a wet hand.

• WARNING: For electrical safety, a leakage current detecting device is incorporated

in the power cord. If leakage current exceeding 10mA is detected, the device will cut off the power supply. In the event of cut-off, unplug the spa and stop using at once. Contact help.kogan.com for assistance in resetting the space. Do not attempt to reset the spa by yourself.

• Caution: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer or connected to a circuit that is regularly switched on and off by the utility.

• Caution: Read the instruction before using the appliance and installation or reassemble every time

• The spa must be supplied through an isolating transformer or supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30mA.

• The pump must be tested before each use. Refer to the PRCD page of the Installation section for instructions.

• If the supplied power cord is damaged, it must be replaced by the manufacturer or Kogan.com representative. Do not use if damaged.

• To reduce the risk of electric shock, do not use extension cord to connect unit to electric supply; provide a properly located outlet.

• No part of the appliance is to be located above the spa during use.

• Parts containing live parts (except parts supplied with safety extra-low voltage not

exceeding 12V) must be out of reach and inaccessible to a person in the spa.

• Parts incorporating electrical components (except remote control devices) must be located or fixed so that they cannot fall into the spa pool.

• The plug of the pump shall be more than 3.5 metres away from the spa at all times.

• It is necessary to have the plug accessible after installation of the spa.

• The power source on the wall of the building should keep more than 4 metres away

from spa and at a height of at least 1.2 metres.

• Do not use extension cords.

• Always unplug the appliance:

o on rainy days

o before cleaning or other maintenance

o if leaving unattended for a long period (holidays, etc)

• The plug shall be directly connected only to a socket-outlet of the fixed electrical installation.

• When the appliance will be not used for a long time, such as in the winter, the spa or pool set should be disassembled and stored indoor.

• Never wear contact lenses when in the spa.

• Do not use spa during chemical maintenance.

• Keep this user guide for future reference. If the user guide is lost, refer to kogan.com

for a digital copy.

• The appliance must be supplied by earthed power source. An earthed power cord is supplied.

• Cleaning and user maintenance must be performed by an adult above 18 years old who is understands the risk of electric shock.

• Do not bury cord. Locate cord to minimize damage from lawn mowers, hedge trimmers and other equipment.

• During pregnancy, soaking in hot water may result in serious injury or death to the unborn child. Limit use to 10 minutes at a time and be conscious of temperature.

To reduce the risk of injury:

• The water in a spa should never exceed 40°C. Water temperature between 38°C and 40°C is considered safe for a healthy adult. Lower water temperatures are recommended for young children and when spa use exceeds 10 minutes.

• Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy, users who are pregnant or possibly pregnant should limit spa water temperature to 38°C.

• Before entering a spa, the user should measure the water temperature with an accurate thermometer since the tolerance of water temperature regulating device varies.

• The use of alcohol, drugs or medication before or during spa use may lead to unconsciousness with the possibility of drowning.

• The use of alcohol, drugs or medication can greatly increase the risk of fatal hyperthermia. Hyperthermia occurs when the internal temperature of the body reaches a level that is several degrees above the normal body temperature of 37°C.

The symptoms of hyperthermia include an increase in the internal temperature of the body, dizziness, lethargy, drowsiness and fainting.

The effects of hyperthermia include failure to perceive heat; failure to recognize the need to exit spa or hot tub; unawareness of impending hazard; fetal damage in pregnant people; physical inability to exit the spa or hot tub; and unconsciousness resulting in the danger of drowning.

• Obese persons and persons with a history of heart disease, low or high blood pressure, circulatory system problems or diabetes should consult a physician before using a spa.

• Persons using medication should consult a physician before using a spa since some medication may induce drowsiness while other medication may affect heart rate, blood pressure and circulation.

• TO REDUCE THE RISK OF INJURY: Never pour water with a temperature higher than 40°C into the spa pool directly.

• Electric installations must follow national wiring rules; consult a qualified electrician with any questions.

• Consult your physician for recommendations.

Caution:

• We strongly recommend not to unfold and inflate the spa if the ambient temperature is below 15°C. We suggest inflating the spa indoors and then continuing set up outdoors. If the outdoor temperature is lower than 6°C, the spa heater must always be on. In this mode, the Freeze Shield system can keep the internal temperature between 6°C and 10°C to prevent damage, such as water freezing in the pipes or the circulation system.

Important: If the Freeze Shield system isn't working, alarms will pop up on the spa. Be sure to check the status of your spa if the outdoor temperature is below 6°C. In case of a longterm absence from home when there is a risk of temperatures falling below 6°C, we strongly suggest disassembling the spa and storing it following the storage procedure.

• Do not use the spa alone.

• People with infectious diseases should not use a spa.

• Do not use the spa immediately following strenuous exercise.

• Always enter and exit the spa slowly and cautiously. Wet surfaces are slippery.

• To avoid damage to the pump, the spa must never be operated unless the spa is

filled with water.

• Immediately leave spa if the user feels uncomfortable or sleepy.

• Never add water to chemicals. Always add chemicals to water to avoid strong

fumes or violent reactions that may result in hazardous chemical spray.

• Refer to the Cleaning and Care section of this user guide regarding information pertaining to cleaning, maintenance of water, and disposal of water.

After using your spa for 3-5 years, you should contact your local qualified maintenance technician to ensure the safety and performance of the spa. The main components, such as heating element, air blower motor and non-return valves within the electric unit should be checked and replaced (if necessary) by professionals.

Note:

• Please examine equipment before use. Notify Bestway at the customer service address listed on this manual for any damaged or missing parts at the time of purchase. Verify that the equipment components represent the models that you had intended to purchase.

• This product is not intended for commercial use.

01 P05158

(x1)

02 P05331

(x1)

03 P05178

04 P04125

05 P6931ASS16

06 P05343

07 P05345

09 F4C009B-

(x1)

Note: Examine equipment before use. Notify Kogan.com support of any damaged or missing parts at

intended to purchase. For reference please use the diagrams below.

(x1)

08 P05524

(x2)

13 P61726ASS18

(x1)

02ASS17

14 P61727ASS18

(x1)

10 P00217

(x1)

15 P05346

(x1)

11 P05320

16 P6609ASS16

(x1)

12 Filter cartridge

(x8)

17 P05347

(x1)

the time of purchase. Verify that the equipment components represent the model that you had

(x1)

(x2)

(x1)

WARNING: The selected location has to be able to support the entire expected load.

indoor and outdoor installations.

4-6

1.5-2˚C/h

1325 L/h

0.8PSI

778 L

807kg

3-4˚F/h

350 gal/h

0.055Bar

205gal

1779Lb

Selecting the Location

An adequate drainage system has to be provided to deal with overflow water for both

IMPORTANT: Because of the combined weight of the spa, water and users, it is extremely important that the base where the spa is installed is smooth, flat, level and capable of uniformly supporting the weight for the entire time the spa is installed. Do not install on carpet or other similar floor surface. If the spa is placed on a surface which does not meet these requirements, any damage caused by improper support is not covered under the manufacturer's warranty. It is the responsibility of the spa owner to assure the integrity of the site at all times. Failure to follow this instruction puts the users in extreme danger.

Notes for Indoor Installation:

Be aware of special requirements if you install the spa indoors.

Humidity is a natural side effect with spa installation. Determine the effects of airborne moisture on surfaces (exposed wood, paper, etc.) in the proposed location. To minimize these effects, it is best to provide plenty of ventilation to the selected area. An architect can help determine if more ventilation is needed.

Notes for Outdoor Installation:

• During filling, draining or when in use, water may flow out of the spa. Therefore, the spa should be installed near a floor drain.

• Do not leave the spa's surface exposed to direct sunlight for long periods of time.

Notes for Winter Installation:

It is important to follow these suggestions if you are setting up the spa during the winter period. This will prevent damage to the PVC material and extend the life of your product drastically.

• If the ambient temperature is below 10°C, we suggest keeping the package indoor where the temperature is above 15°C for at least 2h before inflation. This will make the spa liner more flexible and easier to set up.

• Open the package in the same room where the temperature is above 15°C and inflate the spa using the spa heater.

• Position the spa liner outdoor in the desired position, connect the spa heater and fill with water.

Important: The water temperature used to fill the spa must be above 6°C, otherwise when you begin to operate with the spa heater, the E03 alarm will appear.

Inflation time for reference only, may not be exact.

P6609ASS16

Step 1: Step 2:

Step 3:

Step 4:

+ 22 hidden pages