INSTRUCTION MANUAL
In order to get the best results from the blender, please read the instruction fully before
use. Please store a copy of the manual somewhere safe for future reference.
ATTENTION:
Wrong operation and improper handling can cause faults with the appliance or injury
to the user.
The unit may be used only for the intended purposes. No liability is accepted for
damages arising from improper use or faulty handling.
Before connecting to the power supply, please check whether the type of supply and
the mains voltage match with the details given on the nameplate on the appliance.
Do not immerse the appliance and plug in water or other fluids. Should the appliance
still fall into water, pull out the power plug immediately and have the appliance
checked by an electrical technician before using it again. There is danger to life from
electrical shock!
Do not try to open the housing yourself! Do not introduce any kind of objects into the
housing.
Do not use the appliance with wet hands, on a moist floor or when the ambiance is
humid.
Do not hold the mains plug with wet or moist hands.
Always disconnect the blender from the supply if it is left unattended and before
assembling, disassembling or cleaning; If the supply cord or plug is damaged, it must
be replaced by a Kogan customer service technician in order to avoid a hazard.
Do not operate the appliance if the power cable or the mains plug shows damage or
the unit falls to the floor or has been damaged otherwise. In such cases, contact the
Kogan customer support team for further information.
Do not ever try to repair the unit yourselves. There is danger from electrical shock!
Do not let the power cord hang over sharp edges and keep it away from hot objects
and open flames. Pull the plug itself to remove it from the plug socket.
Installation of a spike protector will offer additional protection with a nominal trigger
current of not more than 30 Ma in the house installation. Please consult an
electrician for information.
The cable as well any extension cable required should be laid such that there will not
be any risk of anyone pulling it inadvertently or tripping over it.
If a long extension cable is used, it must be suitable for the power supply in question.
Otherwise it may cause overheating of the cable and/or plug.
Set the unit on a rigid, flat and heat-proof surface away from open flames (such as a
gas oven) and operate it out of reach of children.
This appliance is suitable neither for commercial use nor for use outdoors.
1
Do not allow children to use the blender without supervision.
This appliance should not be used by children aged from 8 years and below, or
persons with reduced physical, sensory or mental capabilities or lack of experience
and knowledge unless they have been given constant supervision and instruction
concerning use of the appliance in a safe way and fully understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children.
Pull out the plug out of the socket, when the appliance is not in use and also before
cleaning.
Switch off the appliance and disconnect from supply before changing accessories or
putting you hands near any moving parts at all.
Switch off the unit before pulling out the mains plug.
Use only spare parts from Kogan. No liability is taken if incompatible accessories are
used with this unit.
Never carry the unit by its power cord.
Do not remove individual housing components.
Caution: the appliance is in stand-by mode while it remains connected to the
mains supply. Keep out of reach of children or persons requiring supervision.
Care shall be taken when handling the sharp cutting blades, emptying the bowl and
during cleaning.
When mixing hot liquids/foods excess pressure may build up inside the blender, and
this could make the lid come off and the contents splash out. We therefore
recommend that you avoid mixing excessively hot foods and that you only put very
small quantities of hot liquids or foods into the blender.
Do not use the blender for very hard food products, such as bones, shelled nuts,
frozen meats etc., which could either damage the blade or cause the motor to seize.
2
PARTS ITEM
Installation
1． Clean the Measuring cup, jug cover and glass jug before first use.
2． Make sure the unit is turned off and unplugged from power before installation.
3． First fit the Glass cup sealed ring into blade base, then enclose the blade base into
glass jug. Finally turn the glass jug slightly causing it to lock into place.
4． Put the glass jug base on the top of motor main body; please pay attention to match
the position of glass jug and the bulge of the motor main body.
Fill the glass jug with the desired ingredients. Please ensure that materials will not spill
over from cup. (Maximum capacity can not exceed 1500ml)
DO NOT USE THE UNIT WITHOUT ANY MATERIAL INSIDE.
5． Put the jug cover on top of the glass jug and push it down. Insert the closure into the
jug cover and turn till it locks into place.
6. Place the measuring cup on the center of jug cover. The the measuring cup
anticlockwise slightly until it locks into place.
3
1 ． M easuring cup
2 ． Jug cover
3 ． G lass jug
4 ． G lass jug sealed ring
5 ． B lade components
6 ． J ug holder
7 ． M ain body
8 ． P ower cord & plug
9 ． S kidproof feet
10 ． Speed knob
11 ． Speed guide ring
12 ． F unction buttons
13 ． U pper base of
housing
OPERATION
1．Connect the power. Please ensure the speed knob is turned to “OFF” before
connecting the power.
2．The unit is built with a safety design stopping the motor from running if the glass jug is
not sitting and attached to the motor main body properly.
3．Fill the glass jug with the desired ingredients.
4. Put the jug cover on top of the glass jug and fix it into place. Place the measuring cup
on the center of jug cover, turning slightly anticlockwise to lock it into position.
5．Put the blending cup on main body upper base.
6．Turn the speed knob to “ON”. The functions of “SMOOTHIE”（milkshake), “ICE” and
“PULSE” are available. Press whichever button is most suitable for your desired result.
8．To select the blending speed, please more the speed knob between “MIN” (low
speed) and “MAX” (high speed) to choose the required speed.
9．Please allow the unit to rest after one minute of continuous operation.
Speed adjusts and function button
1．SMOOTHIE —
Stainless steel blade base stay at high speed, suitable for
symmetrical blending.
2．ICE —
Stainless steel blade base stay at high speed, running for 0.5 second then
stop for 1 second, suitable for blending ice.
3．PULSE —
Hold the unit by hand during operation. Stainless steel blades stay at
high speed, and unit will only stop working when you turn the speed dial down.
4．MIN —
Stainless steel blade base stay at low speed
.
5．MAX —
Stainless steel blade base stay at high speed
.
6．ON —
Unit connected with electricity，and functions of “SMOOTHIE”, “ICE” and
“PULSE” are available.
7．OFF —
Disconnected from electricity.
Caution:
1.
Over-filling can cause issues with operation. If unit is struggling or ingredients
are overflowing, please turn off the unit and disconnect the power, take out
some ingredients, then plug back in and resume operations.
2.
Do not use unit continuously for times of more than 1 minute.
4
CLEANING AND STORAGE
1.
Do not clean Motor main body, power cord or plug with water.
2.
Clean the engine base with a soft, damp piece of cloth and a mild cleaning agent.
3.
Fill the glass jug half-full with hot water and a little cleaning agent. Let the unit run
on speed 2 until the blending receptacle is clean.
4.
The base with the blades can be taken apart. Unscrew of the base counter-
clockwise. Take out the blades together with sealing ring facing upwards.
5.
Now clean the glass jug, jug cover, closure, base and blades with sealing ring or
speed blender with hot water and some cleaning agent. Dry well before re-using.
Caution! The blades inside of the blending jug and speed blender are very sharp.
6.
Never use aggressive cleaning agents.
7. Store the blender is a safe location away from children.
Warning:
Do not to touch the sharp blades when cleaning. Please wipe clean with a
thick sponge or cloth to avoid injury to your bare hands.
SPECIFICATION
S
Rated voltage：220-240V 50Hz
Power：700W
Capacity：1.5L
Operating time：1 minute
NOTE
：
1. Unit suitable for household use.
2. Do not use for commercial use.
5
Loading...