Kodak PRINTOMATIC User Manual
KODAK PRINTOMATIC
INSTANT PRINT CAMERA
User Manual
3"H | 4.7"W | 0.9"D (7.8 cm | 2.4 cm | 12 cm)
Please read all directions before using the product and retain this guide for reference.
CONTENTS
INTRODUCTION
1
WARNINGS AND SAFETY PRECAUTIONS
2
BATTERY CARE AND CHARGING
3
PARTS AND FUNCTIONS
4
USING YOUR CAMERA
5
FAQ
6
CUSTOMER SERVICE
7
FCC STATEMENTS
8
ELECTRONIC WASTE NOTICE
9
LIMITED WARRANTY
10
3
3
4
5
67
89
10
1011
11
12
2
1. INTRODUCTION
Thank you for purchasing the KODAK PRINTOMATIC Instant Print Camera. This User Guide is intended
to provide you with guidelines to ensure that operation of this product is safe and does not pose risks
to the user. Any use that does not conform to the guidelines described in this User Guide may void the
limited warranty.
This product is intended for household use only. This product is covered by a limited warranty and is
subject to conditions and exclusions. See warranty for details.
2. WARNINGS AND SAFETY PRECAUTIONS
Warning:
– This camera is not waterproof or water-resistant. Exercise caution when using near water.
– Do not use the camera while you are walking, driving or riding a motorcycle as these actions may
result in accidents.
– Do not point the lash close to anyone’s eyes. This may cause harm to the person’s eyesight.
– Turn the power o if:
Foreign objects or water enter the camera.
The camera has been dropped or damaged.
Continued use after the foregoing issues may cause personal injury. Service should only be
performed by a qualiied technician.
– Use the camera in a well-ventilated area. Do not wrap the camera or place it in cloth or blankets. This
may cause heat to build up and deform the housing, resulting in personal injury.
– Do not let sand or other particles get inside the camera, as damage may occur.
– Do not leave the camera in places where the temperature may rise signiicantly, such as inside a car
or under direct sunlight. This may aect the performance of the product.
– This camera is a precision instrument. Do not drop, strike or use excessive force when handling the
camera.
– Before moving the camera, disconnect all cords and cables. Failure to do so may damage cords and
cables, resulting in personal injury or damage to the product.
3
– For optimal performance, use your KODAK PRINTOMATIC in temperatures between 60°F and 90°F
(15.6°C and 32.2°C) and between 20% to 80% relative humidity.
– During extended use, your camera may feel warm to the touch. This is a normal operating
occurrence and does not indicate any product defect or reason to slow down the fun.
3. BATTERY CARE AND CHARGING
Please carefully read and follow these guidelines.
– Your KODAK PRINTOMATIC camera is equipped with a built-in, non-removable 7.4V lithium ion battery.
– To maximize battery performance and life, we recommend that upon irst use you allow the battery
to fully discharge before recharging it.
– To charge your camera, plug it into a wall outlet using the included micro USB cable and any wall
adapter rated for 1 Amp. The battery LED indicator will blink red until the battery is fully charged.
– Your KODAK PRINTOMATIC may take up to 2 hours to fully charge.
– Avoid extremely cold environments as low temperatures can shorten the battery life and reduce
camera performance. Batteries should not be exposed to excessive heat, such as sunshine, ire or
the like.
– Do not disassemble the camera or remove the battery at any time. The battery is not designed to be
removed from the camera, or charged outside the camera. There is a danger of explosion if battery
is incorrectly replaced, and should be replaced only with the same or equivalent type.
Please contact our support team for service.
– When the battery power dips below 10%, the battery LED indicator will glow red and the camera will
not print. At 2% power, your camera will automatically shut o.
– Please be sure to dispose of the camera device and battery at a properly designated recycling
center in your local area.
C&A Marketing UK Ltd is a registered producer of battery and accumulator products
(Registration No. BPRN06318) and of electrical and electronic products
(Registration No. WEE/ JK4235XX) in the U.K. For more information on proper disposal, please
contact our support team.
Lithium ion batteries may cause environmental harm if disposed incorrectly.
4
4. PARTS AND FUNCTIONS
1. Strap Slot (strap not included)
2. Flash
3. Photo Print Exit Slot
4. Camera Lens
5. Micro USB Port
6. Reset Button
7. Speaker
8. MicroSD™ Card Slot
9. Color/B&W Mode Switch
10. Viewinder
11. Shutter Button
12. Power Button
13. Strap Slot
14. Paper Compartment Door Latch
15. Battery Indicator Light
16. Printing Indicator Light
17. MicroSD™ Card Indicator Light
5
Loading...