Kodak PixPro SL-5 User Manual

SMART LENS Camera

User Manual

About this Manual

Thank you for purchasing the KODAK PIXPRO SMART LENS Camera. Please carefully
read this manual and keep it for future reference.

JK Imaging Ltd. reserves all rights of this document. No part of this published manual

may be reproduced, transmitted, transcribed, stored in a retrieval system or translated
into any language or computer language, in any form, by any means, without the prior
written permission of JK Imaging Ltd..

All trademarks mentioned in this manual are used for identification purposes only and

are properties of their respective owners.

This manual is to introduce you how to operate this KODAK PIXPRO SMART LENS

Camera. JK Imaging Ltd. has tried its utmost to ensure the correctness of all contents
here, but reserves the right to modify. All of these contents are subject to change
without prior notice.

Declaration of Conformity

Responsible Party: JK Imaging Ltd.
Address: 1411 W. 190th Street, Suite 550, Gardena, CA 90248, USA

JK Imaging Europe, 71 Clarendon road, Watford, WD17 1DS, UK

Company Website: www.kodakpixpro.com

In this manual:

The memory card referred to in this manual is a microSD Card or microSDHC card.

1

INDUSTRY CANADA

This device complies with Canadian RSS-210.

This device complies with Industry Canada license-exempt RSS standard (s).Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.

Radiation Exposure Statement:

This product complies with the Canadian portable RF exposure limit set forth for an
uncontrolled environment and is safe for intended operation as described in this manual.
Additional RF exposure reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power if such function is
available.

For Customers in Europe

This symbol [crossed-out wheel bin WEEE Annex IV] indicates separate collection
of electrical waste and electronic equipment in the European countries. Please do
not throw the equipment into domestic refuse. Please use the return and collection
systems available in your country for proper, safe disposal of this product.

2

“CE” mark indicates that this product complies with the European requirements
for safety, health, environment and customer protection. “CE” marked cameras are
intended for sales in Europe.

Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive 1999/5/
EC. The following test methods have been applied in order to prove presumption of
conformity with the essential requirements of the R&TTE Directive 1999/5/EC:

- EN 60950-1: 2006+A11:2009 +A1:2010 +A12:2011
Safety of Information Technology Equipment

- EN 50566: 2013
Product standard to demonstrate compliance of radio frequency fields from handheld and
body- mounted wireless communication devices used by the general public (30 MHz — 6
GHz)

- EN 62209-2: 2010
Human exposure to radio frequency fields from handheld and bodymounted wireless
communication devices — Human models, instrumentation, and procedures
Part 2: Procedure to determine the specific absorption rate (SAR) for wireless
communication devices used in close proximity to the human body (frequency range of
30 MHz to 6 GHz)

- EN 300 328 V1.8.1 : 2012

3

Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband
Transmission systems; Data transmission equipment operating in the 2.4 GHz ISM band
and using spread spectrum modulation techniques; Harmonized EN covering essential
requirements under article 3.2 of the R&TTE Directive.

- EN 301 489-1 V1.9.2: 2011
Electromagnetic compatibility and Radio Spectrum Matters (ERM); Electro Magnetic
Compatibility (EMC) standard for radio equipment and services; Part 1: Common
technical requirements.

- EN 301 489-17 V2.2.1:2012
Electromagnetic compatibility and Radio spectrum Matters (ERM); Electro Magnetic
Compatibility (EMC) standard for radio equipment and services; Part 17: Specific
conditions for 2.4 GHz wideband transmission systems and 5 GHz high performance
RLAN equipment.

For Customers in the U.S.A.

Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

4

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

5

Radiation Exposure Statement:

This product complies with the FCC portable RF exposure limit set forth for an
uncontrolled environment and is safe for intended operation as described in this manual.
Additional RF exposure reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power if such function is
available.

6

Safety Notes

Safety notes for this camera

Do not disassemble or repair this camera by yourself.

Do not drop the camera or allow it to hit solid objects.

To prevent the camera from being damaged by moisture, do not use or store the camera

in very humid environments, such as in rain or near bodies of water.

Turn the camera off, remove the battery and the memory card, and dry it within 24

hours if water accidentally comes in contact with the camera.

Do not use or store the camera in dusty places or on a beach to prevent dust or sand

from entering the camera, causing possible damage to it.

Do not use or store the camera in a hot environment or under direct sunlight.

Please do not use in places having high intensity magnetic field, electrostatic and

electric wave interference (for example near a microwave oven), which may cause
failure in receiving signals.

Before you remove the battery and memory card, the camera should be turned off.

Advise to use soft lens cloth to regularly clean the camera’s body.

7

In cleaning the camera body, please don’t use corrosive cleaning agents or those with

alcohol or organic solvent.

If this camera is not in use for a long time, please keep it in a dry and clean condition.

Our company will not pay compensation for any failure of playback of pictures or

videos caused by improper operation.

When using your camera on an airplane, observe the relevant rules specified by the

airline.

Do not place the product where it can be reached by infants and children.

Safety notes for battery

Please use a battery that is the same type as the one included.

Please use the attached charger to charge the battery.

If the liquid leaking from the battery contacts with your skin, please immediately flush

with water and seek medical treatment. If the liquid leaks into the camera, please
contact the retailer.

Please dispose of the wasted battery in accordance with local (national or regional)

regulations.

To prevent the battery from being damaged, do not drop the battery or allow it to hit

solid objects or to be scratched by the objects.

8