Kodak 8004707 - MAX Water & Sport, FUN SAVER Setup Manual

CIS-236
August 2002

CURRENT INFORMATION SUMMAR Y

Opening Instructions for the

KODAK FUN SAVER One-Time-Use Camera

Wear eye protection when opening all cameras.

Wind Off

0

 Check the frame-counter window to make
sure the “0” is aligned with the arrow.

 If not, grip the camera and cover the lens,
press the

thumbwheel

The film is fully rewound when the

wheel

shutter button

until the film is fully rewound.

rotates freely and does not stop or lock.

shutter button

thumbwheel

, and turn the

thumb-

Break Off Film Door

Insert Tool

 Insert the special tool into the end slot.

Remove Film

 Using the special tool, hold the camera firmly
and pull upwards to break off the film door
and remove the film.

• Place the used camera in the

5

Kodak recycle bin.

• Visit our Web site at

www.kodak.com/go/kes

about Kodak’s recycling program.

• Call Kodak’s advertising distribution
center at [phone] to order
a Kodak hand-opening tool.

http://

for details

Opened camera
with film removed.

CAUTION: Before you attempt the
opening tasks, make sure the tool is
fully engaged with the camera body to
prevent tool slippage.

CAUTION: This camera body contains
a high-voltage capacitor and circuit
board. T o avoid electric shock, do not
pry apart the front and back sections
of the camera. Remove only the film
from its respective compartment. If
sections of the camera are separated,

do not touch the circuit board.

© Eastman Kodak Company, 2002

Exposed
Film

Current Information Summaries provide information of limited or specific

application. Responsibility for judging the timeliness and applicability of the

information to a specific photographic use rests with the end user.

CIS-236, Opening Instructions for the
KODAK FUN SAVER One-Time-Use Camera New 8-02

Consumer Imaging

EASTMAN KODAK COMPANY • ROCHESTER, NY 14650

Kodak and Fun Saver are trademarks.