PASS-THRU
TM
DATA PLUGS
• 8 position, 8 contact pass-through type data plugs for
solid or stranded wire
• Works with CAT6 and CAT6A cables
•
Requires pass-through type crimping tool
(VDV226-110 recommended)
Wiring order
Orden de los alambres
8P8C
Ordre de câblage
PASS-THRU
CONECTORES DE DATOS PASS-THRU™
PRISES DE DONNÉES PASS-THRU™
TM
DATA PLUGS
VDV826-705
TM
PASS-THRU
RJ45 CAT6A STP
1 234 5 6 7 8
WARNING: Cancer and reproductive harm. See www.P65Warnings.ca.gov for more information.
1 2 345678
T568-A
T568-B
1
8
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
ENGLISH
1. Strip 1-1/2" to 2" (38 to 50 mm) of cable jacket; trim shielding,
pullstring, and plastic cross-member as necessary (Fig. 1).
If drain wire is present, remove outer foil shield and twist and
2.
loop as shown in (Fig. 2a).
If drain wire is not present, carefully fold back foil shield and
3.
trim foil shield even with far end of external shield.
Untwist and order wires (see wiring order on other side).
4.
Slide wires into and through connector body, ensuring that the
5.
drain wire or foil shield is under external shield (Fig. 2b). Using
hand or oval opening of plier, carefully wrap external shield
around cable. Ensure drain wire or foil shield are captured
inside external shield.
Slide assembly into crimping tool and crimp/trim* (Fig. 3).
6.
Remove from tool; verify & test connections.
7.
RECOMMENDED TOOLS:
•
VDV110-261 Twisted Pair Radial Stripper
•
2100-7 Electrician's Scissors
•
VDV226-110 Pass-ThruTM Modular Crimper
•
VDV501-851 Scout TM Pro 3 Tester
*Crimping tool must be pass-through type.
1-1/2" – 2"
(38 – 50 mm)
FIG. 1
FIG. 2a FIG. 2b
FIG. 3
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
Loading...