Page 1
ENGLISH
INSTRUCTION MANUAL
Borescope for
Android®* Devices
• 10' (3.05 m)
ARMORED
GOOSENECK
• 0.35" (9 mm)
CAMERA WITH
6 ON-BOARD
LED LIGHTS
• CONNECTS
TO MOST
ANDROID®*
DEVICES AND
PCs WITH
WINDOWS® XP
*Android® versions
4.0 or higher
ET16
2 m
ESPAÑOL pg. 9
FRANÇAIS pg. 17
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
IP67
(Camera only)
Page 2
ENGLISH
GENERAL SPECIFICATIONS
Klein Tools ET16 is a borescope with a 0.35 in. (9 mm) camera
surrounded by 6 LEDs and attached to a 10 ft. (3.05 m) armored
gooseneck. ET16 has USB Type C and micro-USB connections for
most Android® smart phones and devices. The camera output is
displayed on the Android® device using the Klein Tools Borescope
App
• Operating Altitude: 6562 ft. (2000 m)
• Relative Humidity: <85% non-condensing
• Operating/Charging Temperature:
• Storage Temperature:
• Controller Dimensions: 3.7" x 1.2" x .94" (94 mm x 30 mm x 24 mm)
• Weight: 1.12 lbs (0.51 kg)
• Camera Output: 640 x 480 pixels
• Camera Frames per Second: 25
• Camera Gooseneck Length: 10 ft. (3.05 m)
• Pollution degree: 2
• Ingress Protection: Camera: IP67 dustproof & waterproof
• Drop Protection: 6.6 ft. (2 m)
14°F to 140°F (-10°C to 60°C)
32°F to 122°F (0°C to 50°C)
Specifications subject to change.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
WARNINGS
To ensure safe operation and service of the instrument, follow
these instructions. Failure to observe these warnings can result in
serious personal injury, re, or electrical shock.
• The borescope, including the camera end, is NOT insulated. Avoid
probing areas where energized conductive elements may be
present. Shut off power to nearby work areas before starting work.
• DO NOT probe moving machinery that could catch the borescope
and/or camera end, and cause harm to the operator and the
Borescope.
• NEVER completely immerse the camera in water or liquids. DO
NOT use the borescope for underwater inspections.
• Avoid probing areas where chemicals may be present.
• NOT intended for use on people or animals.
• DO NOT use near sources of heat.
• Keep steady footing at all times, following ladder safety procedures
when necessary.
NOTE
• DO NOT use if the USB Type-C connector, Micro-USB connector/
adapter, or borescope housing is damaged in any way.
• No user-serviceable parts inside. DO NOT open or attempt to repair.
2 3
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
Page 3
ENGLISH
BACK
FEATURE DETAILS
3
4
SYMBOLS ON BACK OF INSTRUMENT
Wear approved
eye protection
Read
Instructions
Conformité Européenne:
Conforms with European
Economic Area directives
FRONT
Warning or Caution
NOT insulated - Will
NOT protect against
electric shock
Do not probe
moving machinery
WEEE –
Electronics disposal
OPERATING INSTRUCTIONS
CONNECTING YOUR DEVICE TO THE BORESCOPE
1. Turn on your device.
12
2. Connect the appropriate USB connector on the borescope to your
device, i.e., if your device uses a USB-C connector, insert the
USB-C connector 5 directly into your device. If your device uses
a Micro-USB connector, make sure the Micro-USB Connector/
Adapter 6 is fully seated over the USB-C connector 5, then
insert the Micro-USB connector 5 into your device. See
FEATURE DETAILS section.
3. Select the Klein Tools Borescope app on your device. The ET16
will be recognized and begin drawing power from the device's
battery. At this point the Camera LEDs 4 will become operational.
Rotate the Camera LED Brightness Control 1 to control the
brightness and/or turn the LEDs off.
NOTE: The app will open in Display mode, with the camera displaying
5
an image.
Camera LED Brightness Control
1.
10 ft. (3.05 m) Gooseneck
2.
Camera
3.
Camera LEDs
4.
USB Type-C Connector
5.
Micro-USB Connector/Adapter
6.
6
NOTE: There are no user-serviceable parts inside.
4 5
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
Page 4
ENGLISH
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
DISPLAY MODE
BUTTON/ICON DETAILS
Photo/Video screen icon
A.
Camera image
B.
Settings icon
C.
Rotate Image button
D.
Photo button
E.
Video start/stop button
F.
Elapsed Time (Video)
G.
H L I
M
A C
B
D E F
Appearance
while recording
PHOTO/VIDEO FILE MENU
BUTTON/ICON DETAILS
Previous Screen
H.
Select Items
I.
Video Menu
J.
Photo Menu
K.
Active Menu (Photo or Video)
L.
Files
M.
G
FILE MANAGEMENT MODE
R
BUTTON/ICON DETAILS
Copy or send selected file
N.
Delete selected file
O.
Exit Edit Mode (when in Edit Mode only)
P.
File Selected Indicator
Q.
Review Mode: File name
R.
Manage Mode: Files selected
ROTATING THE CAMERA IMAGE ON THE APP SCREEN
Sometimes it may be necessary to rotate the camera image relative
to the app screen. Each tap of the Rotate Image button
the image clockwise in 90° increments. This does not affect the
rotation of the entire app screen, just the camera image.
TAKING PHOTOS
While in Display mode, aim the camera
photographed and tap the Photo button
at the subject to be
6
to take a photo.
E
CAPTURING VIDEO
While in Display mode, aim the camera
recorded and tap the Video Start/Stop button
video, the elapsed time will be shown
button
will turn red and display the square Stop symbol. To end
F
the recording, tap the Video Start/Stop button
Start/Stop button
will return to its normal appearance.
F
at the subject to be
6
F
, and the Video Start/Stop
G
F
NOP
Q
will rotate
D
. While recording
again. The Video
J
L K
6 7
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
Loading...