PRO DI 10P
Passive DI Box with Stereo Input / Summed Mono Output,
MIDAS Transformer and Extended Dynamic Range
INPUTS – Connect your source audio via s tereo RCA jacks or a single ⁄" TRS jack. The unused input jack can act as a loop-through output. A mono source can also be connected to one
of the RCA jacks, or to the ⁄" input.
LEVEL L/R – The level of the lef t and right channels can be adjus ted before being sent to the out put jack. Normally these knobs should be set fully clock wise, but may be used to
attenuate very hot signals, or to correc t the balance between the channels.
OUTPUT – Send the summed inputs to a mixing console via balanced XLR cable. The output level is approximately 20 dB lower than the input signal.
EARTH LIFT – This switch may help reduce unwanted hum by removing the ground connec tion.
Speci cations
Inputs
Connector s RCA unbalanced, ⁄ TRS
Impedance 7 k
Outputs
Connector XLR , balanced
Impedance 170
System
Frequency response 10 Hz to 91 kHz (± 1 dB)
THD + N (distortion) <0.03% @ 1 kHz, +4 dBu
Signal-to-noise ratio >120 dB @ 1 kHz, +4 dBu
Power requirement Passive
Physical
Dimensions (WxDxH) 64 x 118 x 112 mm
Weight 0.47 kg (1.0 lbs)
(2.5 x 4.7 x 4.4")
LEGAL DISCLAIMER
MUSIC Group accepts no liability for any loss which may be su ered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein.
Technical speci cations, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. MIDAS, K LARK TEKNIK,
LAB GRUPPEN, LAKE, TANNOY, TURBOSOUND, TC ELECTRONIC, TC HELICON, BEHRINGER, and BUGERA are trademarks or registered trademarks of MUSIC Group IP Ltd.
© MUSIC Group IP Ltd. 2017 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding MUSIC Group’s Limited Warranty, please see complete details online at
music-group.com/warranty.
klarkteknik.com
Loading...