KJB TD2300 Specsheet

Transducer for White Noise Generator (Item: TD2300)

The TD2300 vibroacoustic transducer is part of a complete counter
surveillance protection system. It inducts noise into walls, floors,
ceilings, windows and other surfaces of the building,preventing
leakage of sound signals. To provide a sufficient level of protection the
system consists of a number of transducers installed on different
structures in the room and is connected to the DNG-2300 generator.

Need more transducers, determine the quantity of
transducers needed by these recommendations:

WALLS - One placed every eight linear feet, centered between floor

and ceiling. Mount on or within
6 inches of a stud.

FLOOR and CEILING - One centered on every 64 square feet. (Use
the OMS-2000 speaker for drop

ceiling.)

WINDOWS - One placed on every major pane of glass within 6" of the
corner.

DOORS - One placed adjacent to the center hinge on the doorframe.

Features:

Attractive design, looks good in any interior
High power output,
Small Size
Fits well on windows, walls and other structures
The included mounting set makes it possible to install the
transducer on any surface
Passes most of the generated noise into the desired
construction in the form of vibration, while also producing less
audible interference
The frequency characteristics optimally correspond to the
spectrum of human speech
Perfectly suited for the DNG-2300 white noise generator

Buy a kit with DNG2300 white noise Generator, Omni masking
speaker and Transducer the DNG230

0-4 Kit or the DNG2300-8 Kit

• Impedance 4 Ohm

• Frequency response 58 Hz -12 kHz

• Power 10W

• 1 Transducer

• Spacer

• bolt, double ended

• Screw double ended

• Plastic Anchor

• Mounting disk

• Metal Wall anchor

Powered by TCPDF (www.tcpdf.org)