KitchenAid YWMT55511K, YKMBT5511K, YWMT50011K, YKMBT5011K Installation Instructions

BUILT-IN MICROWAVE WITH TRIM KIT
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION DU FOUR À
MICRO-ONDES ENCASTRÉS AVEC GARNITURE
Built-In Microwave with Trim Kit Models / Modèles de four à micro-ondes avec garniture
Standard Models / Modèles standard: YWMT55511K, YKMBT5511K
Slim Models / Modèles minces: YWMT50011K, YKMBT5011K
Table of Contents / Table des matières
MICROWAVE OVEN SAFETY ........................................................1
INSTALLATION REQUIREMENTS .................................................2
Tools and Parts .............................................................................2
Location Requirements ................................................................3
Not installed over a built-in oven .................................................3
Installed over a built-in oven ........................................................3
Product Dimensions .....................................................................4
Required Cutout Dimensions .......................................................5
Electrical Requirements ...............................................................6
INSTALLATION INSTRUCTIONS ...................................................7
Unpacking Instructions ................................................................7
Prepare Microwave Oven .............................................................7
Install the Rails .............................................................................8
Install the Microwave Oven ..........................................................9
Secure the Trim Kit Frame ...............................................................9
SÉCURITÉ DU FOUR À MICRO-ONDES ...................................10
EXIGENCES D’INSTALLATION ...................................................11
Outils et pièces ...........................................................................11
Exigences d’emplacement ......................................................12
Non installé au-dessus un four encastré ...................................12
Installé au-dessus un four encastré ...........................................12
Dimensions du produit ...............................................................13
Dimensions requises des ouvertures à découper .....................14
Spécicationsélectriques ..........................................................15
INSTRUCTIONS D’INSTALLATION ............................................. 16
Instructions de déballage ...........................................................16
Préparation du four à micro-ondes ............................................16
Installation des glissières ...........................................................17
Installation du four à micro-ondes .............................................18
Fixer le cadre de garniture .........................................................18
UL listed for use over electric built-in oven, 30" (76.2 cm) wide. This appliance is a built-in microwave with trim kit, do not use as countertop microwave oven.
Homologué UL pour une utilisation au-dessus d’un four électrique encastré de 30po (76,2cm) de large. Cet appareil est un four à micro-ondes encastré avec garniture; ne pas utiliser comme four à micro-ondes de comptoir.
MICROWAVE OVEN SAFETY
W11412754B
INSTALLATION REQUIREMENTS
Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
■ Measuring tape
■ Pencil
■ Phillips screwdriver
Screw Pack Supplied (not shown to scale)
SCREW SCREW ART QTY
#7-18x7/16" round- head sheet metal screws
#7-16x15/16" at head wood screws
#7-16x7/16" round-head wood screws
NOTE: There are some extra screws in the screw pack. They are spares for your use during installation if needed. See below:
■ #7-18x7/16" round-head sheet metal screw: 4 extra
■ #7-16x15/16" at head wood screw: 2 extra
■ #7-16x7/16" round-head wood screw: 4 extra
Parts supplied (not shown to scale)
This installation instruction is for various models. Some parts supplied may have different appearance, depending on your model. NOTE: Trim kit frame (1), Cooling Ducts (2) and Rail (2) parts will
need to be purchased to convert from Standard to Slim or from a Slim to a Standard installation.
Parts supplied for model: YWMT50011K and YKMBT5011K
PART PART ART QTY
Trim kit frame (slim)
■ 7/64" (2.8 mm) drill bit
■ Drill
14
6
10
1
Parts supplied for model: YWMT55511K and YKMBT5511K
PART PART ART QTY
Trim kit frame (standard)
Cooling duct (standard)
Rail (standard)
1
2
2
Parts supplied for all models
PART PART ART QTY
Turntable
Turntable ring
Turntable driver
1
1
1
NOTE: The turntable driver is located inside the microwave oven cavity. Remove the tape before use.
Cooling duct (slim)
Rail (slim)
2
2
2
Location Requirements
This is a built-in appliance. Do not use as countertop microwave oven. This microwave oven must be installed into a wood cabinetry. The location must provide:
■ Cutout opening that is plumb and square.
■ Cutout oor that is solid, level and ush with bottom of cabinet cutout.
■ Support for weight of at least 150 lbs (68 kg), which includes microwave oven and items placed inside.
■ There must be minimum of 36" (91.4 cm) from the oor to cut-out oor. See pictorial below.
■ Grounded electrical outlet. See “Electrical Requirements” section.
■ Minimum installation clearances for installation location. See “Required Cutout Dimensions” section.
■ Complete enclosure around the recessed portion of the microwave oven.
■ Mounting distance between a xed wall on the hinged-side of the door and the microwave oven is 0.5" (1.3 cm).
Not installed over a built-in oven
2"
(5.1 cm)
B
1
"
(4.0 cm)
C
D
A. Upper cabinet B. Microwave oven cutout
1. Minimum distance of 36" (91.4 cm) from the oor to the
cutout oor.
2. The microwave oven may also be installed in a cabinet by
itself (without a built-in oven below). Allow a clearance of at
9
/16" (4.0 cm) below the cabinet.
least 1
3. Make sure the surrounding cabinetry has clearance to open
and close freely. Allow a clearance of at least 2" (5.1 cm) above the cutout opening.
C. Lower cabinets D. Floor
A
min.
36"
(91.4 cm)
Installed over a built-in oven
A
B
F
min.
36"
(91.4 cm)
D
A. Upper cabinet B. Microwave oven cutout
D. Floor F. Lower oven cutout
1. Minimum distance of 36" (91.4 cm) from the oor to the
cutout oor.
2. The microwave oven may be installed over a built-in oven. If
installing over a built-in oven, make sure there is a minimum of 3" (7.6 cm) between the top of the lower oven cutout and the microwave oven cutout oor.
3. Make sure the surrounding cabinetry has clearance to open
and close freely. Allow a clearance of at least 2" (5.1 cm) above the cutout opening.
2"
(5.1 cm)
3"
(7.6 cm)
3
Product Dimensions
F
E
B
D
G
J
C
H
A
Unit Measurement Slim models Standard models
in cm in cm
A Width of unit with trim kit frame 29¾ 75.6 29¾ 75.6
1
B Height of unit with trim kit frame 14 35.6 19
/
8
C Depth of unit 18 45.7 18 45.7 D Height of unit without trim kit frame 10 E Width of unit without trim kit frame 27
/
16
13
/
16
26.2 105/
70.7 2713/
16
16
5
F Trim kit frame thickness (visible) 7/8 2.2 7/8 2.2 G Total thickness of frame 2
/
16
5.8 25/
16
5
H Trim kit frame inner opening width 28 71.1 28 71.1
9
J Trim kit frame inner opening height 10
/
16
26.9 109/
16
48.6
26.2
70.7
5.8
26.9
4
Required Cutout Dimensions
J
Back of the
microwave oven
Back of the
Cabinet
Receptacle
e
Wooden Cabinet
B
F
E
H
A
C
D
Recommended Receptacle Location
G
Cabinet Cutout Measurement Slim models Standard models
in cm in cm
1
A Width of cabinet opening 28
/
2
B Height of cabinet opening 12 30.5 17
3
C Depth of cabinet opening Minimum 21
/4" (55.2 cm) with ush receptacle
72.4 281/
2
1
/
8
72.4
43.5
D Trim kit frame overhang-lower frame 1 2.54 1 2.54
E Trim kit frame overhang-upper frame 1 2.54 1 2.54
F Trim kit frame overhang-left frame 5/8 1.6 5/8 1.6 G Trim kit frame overhang-right frame 5/8 1.6 5/8 1.6 H Recommended region for receptacle Upper right quadrant
J Receptacle surface to the back of the
4" (10.2 cm) < J < 40" (102 cm)
microwave oven
NOTES:
■ Flush receptacle is recommended. For non-ush receptacle, make sure you have at least 4" (10.2 cm) clearance between the back
of microwave oven and the receptacle.
■ If the receptacle is placed outside of the recommended region, make sure from the back of the microwave oven to the receptacle
must be within 40" (102 cm). Otherwise, the power cord is not long enough to plug in.
■ Tolerance for width and height of cabinet opening is 1/16"(2mm).
5
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Observe all governing codes and ordinances.
Required:
■ A 120 V, 60 Hz, AC only, 15 or 20 A electrical supply with a
fuse or circuit breaker
Recommended:
■ A time-delay fuse or time-delay circuit breaker
■ A separate circuit serving only this microwave oven
GROUNDING INSTRUCTIONS
For all cord connected appliances:
The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
This device complies with Part 18 of the FCC Rules.
This device complies with Industry Canada ICES-001.
6
Loading...
+ 14 hidden pages